The simulation results indicate that the slot gating system is difficult to obtain the favorable filling sequence because of the excessive high of the casting,the liquid metal splashes badly during the mold-filling stage.
模拟结果表明,由于铸件较高,缝隙式浇注系统无法实现逐层充填,金属液在充型过程中飞溅严重。
Influence of Technological Parameter on Mechanical Properties of ZL205A in Vertical Pouring System;
缝隙式浇注系统条件下工艺参数对ZL205A合金性能的影响
The Simulation of the Micro-Part's Weld Lines by Injection Molding;
对微注射成型浇注系统与微制件熔接缝形成的CAE模拟研究
Closed Integration System for Melting and Pouring Magnesium Alloy
封闭式镁合金熔炼及浇注集成系统的研究
Study of the calculating formulas in the minimum section of the gray casting iron pouring system
灰铸铁件浇注系统最小截面积计算公式研究
Design of Pb-Ca Alloy Automatic Casting System Based on The S7-300PLC
直线往复式铅钙合金自动浇注系统设计
Application of the slit type metal filter and completely automatic sand filter in circulating water systems
缝隙式金属过滤器和全自动砂滤器在循环水系统的应用
The Secondary Development of Autocad for Feed System of Injection Mold;
注塑模浇注系统的AutoCAD二次开发
Design of Injection Mold Gating System of the Plastic Gear Based on MoldFlow Software
基于MoldFlow塑料齿轮注射模浇注系统设计
The Design and CAE Analysis in Multy-carities Injection Moding Feed System
多型腔注塑模浇注系统设计及CAE分析
Research on Atomization Patterns for Cracks Hole Style Fuel Injection Nozzles
缝隙孔式喷油嘴偶件燃油喷注雾化形态的研究
Study of Monolithic Pouring Derivative PDMS Chip-based Electrophoresis Microsystem and Its Application;
衍生式整体浇注PDMS芯片电泳微系统及其应用研究
Analysis and Control of Weld Marks of Auto Lamp Reflector Based on Valve-injection
基于阀式浇注系统的车灯反射体熔接痕的分析与控制
Effects of Binders on Properties of Alumina Magnesia Based Castable
不同结合系统铝镁浇注料的性能研究
The Development Research of Gating System of Die Casting Based on Pro/Engineer
基于Pro/E的压铸模浇注系统开发
Design of Injection Systerm of Lost Foam Casting under Negative Pressure
消失模负压铸造浇注系统设计的探讨
Application of Fully-poured Bus in 6kV Auxiliary Power System
全浇注母线在6kV厂用电系统中应用
Moldflow-based optimization analysis of gating system for umbrella framework
基于Moldflow的雨伞骨架浇注系统优化分析
Study on Gating System of Aluminium Alloy Shell Casting Based on CAE
基于CAE铝合金壳形件浇注系统的研究