It has been found the oxidation resistance of casting forming Sialon/SiC is the best,the pressure forming Si3N4/SiC is the worst,and the pressure forming Sialon/SiC is the middle one.
结果表明,浇注成型Sialon/SiC试样抗氧化性能最好,压力成型Sialon/SiC试样次之,压力成型Si3N4/SiC最差,并得到其氧化动力学方程。
Phosphogypsum lightweight wall-bricks were prepared by the approach of pretreatment and the casting moulding.
研究磷石膏的预处理方法和浇注成型法制备磷石膏轻质墙体砖。
Study on Strength Properties of Phosphate Bonded Core Used in Investment Cast and Formed by Pouring;
熔模铸造用浇注成形磷酸盐粘结型芯强度研究
This paper presents an improved design of the mixing-pouring truck introd uced from abroad.
介绍了对引进加气混凝土搅拌浇注车的改进设计。
Optimization of feed system and design of injection mould for automotive engine cover
汽车发动机罩盖浇注系统优化与注射模设计
Anti-warpage Gate Design Analysis for Injection-molded PBT Long-armed Lamp Holders
车用PBT长臂灯架防翘曲注射浇口设计分析
Runner System Optimization of Transit Automobile Bumper Based on CAE
基于CAE的全顺汽车保险杠浇注系统优化研究
Analysis on Entrapped Slag Defect of Cast Steel Wheel Poured Continuously by Bottom Pouring Ladle
用底注包连续浇注铸钢车轮产生夹渣缺陷的分析
The vehicle stands on the finished concreted tunnel Base with the direction of travel corresponding to the direction of lining.
车辆位于浇注好的隧道基底上,移动方向与衬砌方向一致。
Application of Multi-gates Sequence Control Technology in the Injection Molding of Auto Lamp Lens
多浇口顺序控制技术在车灯面罩注射成型中的应用
Analysis and Control of Weld Marks of Auto Lamp Reflector Based on Valve-injection
基于阀式浇注系统的车灯反射体熔接痕的分析与控制
Quality Evaluation of JZ35 Axletree Billets Produced by Different Casting Process
采用不同浇注工艺生产JZ35车轴用钢坯的质量评价
Pour a solid foundation of cement
浇注坚实的水泥地基
concreting boom
浇注混凝土起重机臂
connecting rod babbitting jig
连杆巴氏合金浇注器
connecting rod bearing pouring
连杆轴承巴氏合金浇注
A mold for the setting of concrete.
模板浇注混凝土的模板
Cast Process of Winding in Epoxy Resin Cast Dry-Type Transformer
环氧树脂浇注干式变压器的绕组浇注工艺
cart with a tank and sprinkler for sprinkling roads.
盛水的用来浇路面的车。
Technology of Inclined Cast Avoid Appeared the Defects of Misrun in Oven Door Casting
倾斜浇注防止焦炉炉门铸件产生浇不足缺陷
The Secondary Development of Autocad for Feed System of Injection Mold;
注塑模浇注系统的AutoCAD二次开发