With initial brightness and afterglow time as indexes,the effects of calcining heat,mass ratio of urea and nitrate,boric acid mole fraction,mol ratio of Dy and Eu on the preparation technology are discussed.
为了探讨SrA l2O4:Eu2+,Dy3+磷光体的最佳制备工艺,利用正交设计法对合成条件进行了优化,以初始亮度和余辉时间为指标,考察煅烧温度、尿素与硝酸盐的质量比、硼酸的物质的量分数、镝与铕物质的量比对制备工艺的影响。
Na_8+Na_8 collisional dynamics at different initial temperatures;
不同初始温度时Na_8+Na_8团簇碰撞动力学研究
The initial temperature distribution function of the foundry moulds when heat radiated and infused by hot iron are put forward.
提出了铸型受热辐射和铁水浸泡的初始温度分布函数，并考虑了结晶潜热和强制冷却工艺等因素，使模拟精度高，误差在５％以内，为研究厚大断面球铁铸件的凝固规律提供了较可靠的参考依据。
How to determine initial temperature and adiabatic temperature rise is one of the most principal factors for RCC(Roller Compacted Concrete) dam,which will influence the accuracy and quantity of simulation analysis for temperature field.
碾压混凝土浇筑层的初始温度和绝热温升是碾压混凝土坝设计中的常见问题之一,直接关系到温度场仿真计算的精度和计算量问题。
The influences of the initial concentration,humus and brine on hydrolysis of bispyribac-sodium were studied.
采用室内实验方法,研究了农药的初始浓度以及水中存在的腐植酸、盐类物质对双草醚钠盐水解作用的影响。
In this experiment,we applied the purified Bt protein into soil to simulate the degradation of Bt protein in soil under natural conditons and study the effect of sterilization,temperature,pH,initial concentration on the degradation of Bt protein by ELISA for the sake of providing scientific basis for the evaluation of eco-environment risks caused by transgenic Bt crops.
本文将纯化的Bt蛋白直接加入土壤中,模拟自然状态下Bt蛋白在土壤中的降解,利用ELISA检测法,研究灭菌、温度、pH、初始浓度等对其降解的影响,以期为评价转Bt基因作物释放可能引起的生态环境风险提供科学依据。
The effects of number and size of elements in the contact area in the steady stage of a rolling process as well as the initial velocity of the plate on the finite element analysis were analyzed and reasonable simulation parameters in a rolling process with FEM were attained, which was used to analyze the rolling force regularity of medium plat rolling in one steel work.
分析了轧制过程稳定阶段接触区中厚板单元数、轧辊单元尺寸以及中厚板初始速度选择对有限元分析计算结果的影响, 得出了合理的轧制过程有限元模拟参数, 并对某中厚板厂15道次轧制过程轧制力变化规律进行了分析, 稳定阶段轧制力计算结果与实测结果非常接近。
The program indicates that the initial velocity is a variable.
根据Ｂｒｉｄｇｍａｎ 法生长ＨｇＣｄＴｅ 晶体过程中溶质ＣｄＴｅ 的分布规律，推导了缩短初始过渡区长度、增加组分稳定区长度的最佳初速度表达式，从式中可看出：初始速度为一变数。
Resorting to Runge-kutta method to solve the simply supported axial pre-statically loaded bar s buckling impulse under the half-sin impact load, this paper is to probe into the relationship between buckling impulse, and pre-static load, impact load, initial deflection, initial velocity respectively.
运用龙格 -库塔方法求解两端简支的轴向预静载杆在半正弦冲击载荷作用下的屈曲载荷 ,分析屈曲载荷与静预载 ,冲击载荷 ,初始几何缺陷 ,初始速度之间的关
It includes: 1 .the hardware initialize code when system power on .
它包括：1．在一个系统被引导时，目标系统硬件初始化程序。
It not only initializes the hard disks but also the network as you need a network to mount nfs file systems.
当安装一个nfs文件系统时不但要初始化 硬盘还需初始化网络。
The indicated device requires reinitialization due to hardware errors.
由于硬件错误，显示设备需要重新初始化。
Windows Initialization Files
Windows初始化文件
It provides hardware linking method, baud rate calculation and communication ports initialization.
给出了两机的硬件连接方式、波特率确定和软件对通信端口的初始化。
These codes finish the initializing of the hardware and software environment, it is the key part of designing the embedded system.
这些代码完成系统硬件和软件运行环境的初始化，是设计嵌入式系统开发的关键部分。
If this output does not switch between H and L anymore a hard-ware reset is produced and the processor is initialized again.
如这个输出不再在高电平和低电平间作切换，硬件复位就会产生，并将处理器再次初始化。
Thehardening curve can be pided into three stages, i. e. first, rapid-hardening andsaturated stage.
循环硬化曲线可以分成三个阶段:初始阶段、速硬化阶段和饱和阶段。
Winsock is uninitialized
未初始化 Winsock
Snapshot files are always available to immediately initialize new subscriptions
始终可以使用快照文件来立即初始化新订阅
Snapshot files are always available to initialize new subscriptions immediately
始终可以立即使用快照文件初始化新订阅
"A Setup initialization file has been corrupted.
"有一个安装程序初始化文件已被破坏。
You cannot initialize the workflow folder while offline.
脱机时无法初始化工作流文件夹。
initialize an APTo select an AP software version
初始化 AP选择一个 AP 软件版本
Event %1.%2 may fire when form is intialized.
初始化窗体时可能激发事件 %1.%2。
The event representing the initialization of the transient provider.
事件代表暂时提供程序的初始化。
Failed to initiate the module. Please make sure the module file exists.
模块初始化失败。请确认模块文件存在。
Usage Analysis Wizard: Error in initializing user control.
使用分析向导：初始化用户控件时出错。