Ultrasonic wire bonding between Au contact electrode of CdZnTe wafer and down-lead wire
CdZnTe接触电极与引线的超声波焊接
Electrical detection with non-contact electrode;
基于不接触电极的电阻率探测方法
Simulations and tests of non-contact electrode method for complex resistivity exploration;
不接触电极复电阻率法仿真与实验(英文)
The survey technology of non-contact electrode electrical method which is used for carrying on investigation of the engineering geology and the resource prospecting is a new electrical prospecting method.
不接触电极电法测量技术是用来进行工程地质勘探以及资源勘查的一种新的电法勘探方法。
This results in a fourfold increase of heat (Correspondingly,heat drops by 75% if current density is reduced by half, e.g. by doubling the effective electrode contact area.
相应地，如果将有效的电极接触面积加大一倍，电流密度将减少一半，热量则减少75%。
The contact area between clamp and terminal is either silver or copper.
夹头和电极之间的接触面是银的或铜的。
base ohmic contact
基极欧姆［电阻］接触
Ultrasonic wire bonding between Au contact electrode of CdZnTe wafer and down-lead wire
CdZnTe接触电极与引线的超声波焊接
Surface Treatment, Metal Electrode Contact and Indium Doping Behavior of Cd_(1-x)Zn_xTe Crystals;
碲锌镉晶体表面处理、金属电极接触特性及其In掺杂行为
Effects of Pre-and Post-surface Treatment on Ni-based p-GaN Ohmic Contact
Ni基电极淀积前后表面处理对p-GaN欧姆接触的影响
Study of the improvement of Ni/Au ohmic contact to p-GaN by Pt~+ implantation
p-GaN表面Ni/Au电极欧姆接触特性的Pt~+注入改性研究
We should consider the stripe-contact device.
我们应考虑这个条形电极接触器件。
Generation of transmit signal in untouched electrode method exploration;
不接触电极法测量中发射信号的产生
Optimized Process of Thermal Treatment of Au/CdZnTe Contacts
Au/CdZnTe电极接触的热处理优化工艺(英文)
The Development of Untouched Electrode Method Receiver Based on Embed PC104;
基于嵌入式PC104的不接触电极法接收机设计
Electrical Characterization of ZnO Nanowires Contacted to Tungsten Electrodes
钨电极与氧化锌纳米线接触的电学特性
Galvanic Corrosion of AM50 Magnesium Alloy with Cathodic Electrophoretic Coating and Q235 Steel
具有阴极电泳涂层AM50镁合金与钢接触电偶腐蚀
contact with electricity or electric discharge
触电或接触放出的电流
electro-contact type surface roughness tester
电接触式表面粗度试验仪
Bus bars shall be fabricated and contact surfaces (shall be) ground before plating.
电镀前母线须装配完毕且磨平接触面。
2. EX PARTE CONTACTS
（二）单方面接触。
It can generate heat if the positive and negative terminals of the batteries are accidentally contacted by a metallic object.
如果电池的正极和负极端子无意中与金属物品接触会发热。