Carry out a research into the application of bipolar thyristor to the carburizing furnace control systom.
对双向晶闸管在渗碳炉控制系统中的应用进行了研究。
With respect to the carburizing furnace, this paper offers a detailed analysis of a single-chip computer control hardware system, including the temperature control and the carbon potential control.
对渗碳炉的主回路和控制回路进行了设计,详细分析了渗碳炉单片机控制的硬件系统,它包括温度控制和碳势控制。
A newly developed BBH pre - vacuum - pumping carburizing furnace has been introduced in this paper.
介绍了新研制的预抽真空式可控气氛气体渗碳炉。
The key points of design and manufacture for ultra large tye well gas carburizing furnace depend on furnace temperature and carbon- potencial uniformity as well as its control.
超大型井式气体渗碳炉的设计和制造关键点在于炉温的均匀性和碳势的均匀性及其控制,在投入运行后的关键点在于如何防止长时间高温状态下的高温蠕变和热变形对炉罐等部件的影响等。
A new research & development of continuous gas carburizing furnace is described.
介绍了新研制的网带连续式气体渗碳炉。
When repairing old seal up box type carburizing furnace, the furnace lining radiation tube etc.
在老式密封箱式渗碳炉的大修中更换了炉衬、辐射管等主要构件,利用原有的轨道、料盘、小车、推头、炉门、管道等构件,并进行触摸屏控制,用先进技术对老设备进行技术改造,各项技术性能指标均达到现代箱式渗碳炉的水平。
Application of PC Bus Industry Control Computer in Alteration ofCementite Furnace
PC总线工业控制机在渗碳炉的应用
Designing and Model Founding and Stability Analyzing of the Fuzzy Control System of Carburizing Resistance Furnace;
渗碳炉模糊控制系统设计与建模及稳定性分析
Infiltrating-carbon Furnace Temperature Control System on the Basis of Fuzzy PID Control;
基于模糊PID控制的渗碳炉温控系统研究
Computer monitoring and control for pit-type carburizing furnace based on IPC-PLC
基于IPC-PLC的井式渗碳炉计算机监控系统
continuous bright carburizing quenching furnace
连续式光辉渗碳淬火炉
The result shows that carburization was the major factors inducing the failure of the furnace tubes.
结果表明,渗碳是引起炉管失效的主要因素。
DEVELOPMENT AND INDUSTRIAL EXAMINATION OF A LOW COKING AND CARBURIZATION RESISTANT COATING FOR ETHYLENE PYROLYSIS FUR-NACES:PARTⅡ
延缓裂解炉管结焦和渗碳的涂层开发与工业考核(二)
DEVELOPMENT AND INDUSTRIAL EXAMINATION OF A LOW COKING AND CARBURIZATION RESISTANT COATING FOR ETHYLENE PYROLYSIS FURNACES:PART I
延缓裂解炉管结焦和渗碳的涂层开发与工业考核(一)
The basic concepts for improving anti-carbonation performance of ethylene cracking furnace lubes by surface modification are proposed based upon the carbonation process of the furnace tubes of elhylene cracker.
针对乙烯裂解炉管的渗碳过程,指出了采用表面改性技术提高乙烯裂解炉管抗渗碳性能的基本思路。
liquid carbonitriding
液体碳氮共渗, 液体渗碳氮化法
Model for the distribution of carburized case depth of spur gear in warm forming after car burizing
直齿轮“渗碳-温挤”渗碳层厚度分布模型
case hardening grade alloy gear steel
渗碳(皮硬)级合金齿轮钢
Gas Nitrocarburzing for 4Cr5MoSiV1 Steel
4Cr5MoSiV1(H13)钢的气体氮碳共渗
Study on the hydrogen embrittlement phenomena of carbonitriding tape gear;
合金渗碳钢锥齿轮碳氮共渗的氢脆现象研究
Surface Compound Treatment of C-N Multi-elements and RE-B-C-N Multi-elements Deep-penetrating
碳氮共渗-深层稀土硼碳氮共渗复合处理
CO firing waste heat boiler
一氧化碳燃烧废热锅炉
ELO-Vac process
电炉真空脱碳脱气法
INVESTIGATION OF THE ACCURATE CONTROL ABOUTSURFACE CARBON CONCENTRATION OF CARBURISING PART
渗碳零件表面碳浓度精确控制的探讨