The experimental investigation on the low pressure spray characteristics of swirl pressure nozzle was carried out with the water as the working fluid of spray.
以自来水为喷淋介质,对旋流压力式喷嘴低压喷淋特性进行试验研究。
Taking clean water as the working medium,cold state tests of pressure nozzles with 3 different bore diameters were performed.
对压力式喷嘴雾化特性,如喷嘴流量、流量系数、雾化角及雾滴索泰尔平均直径(SMD)等参数随压力和喷嘴孔径的变化关系进行了研究,并根据实验数据计算处理绘制出相关的喷嘴性能实验曲线。
Experimental equipment had been established to research atomization characteristics of a type of pressure nozzle.
建立了雾化实验装置,以甘油-水混合液为介质,研究了一种压力式喷嘴的雾化特性。
Experimental Research on Atomization Characteristics of Pressure Nozzle and Numerical Simulation on Heat and Mass Transfer in Spray-Dryer;
压力式喷嘴雾化特性实验研究及喷雾干燥热质传递特性数值模拟
high pressure nozzle spray drier
高压喷嘴式喷雾干燥机
Three Dimensional Numerical Simulation on Single Atomizer Blend Flow Pressure Spray Dryer;
单喷嘴混流压力式喷雾干燥塔三维数值模拟
Measure Methods of Spray Distribution in Radial Direction of Pressure Atomization Nozzle
压力式雾化喷嘴径向喷淋密度的测量方法
aperture atomizer
喷孔式喷油嘴喷雾器
Research on Double-nozzle Electro-hydraulic Servovalve Driven by Piezoelectric Actuator;
压电驱动式双喷嘴电液伺服阀的研究
Experimental Study of Hydrajet Nozzle on Abrasion
水力喷砂射孔压裂喷嘴的损伤试验与分析
CFD Analysis for Effect of Injection Pressure Fluctuation on Cavitating Flow in Diesel Engine Nozzle
喷油压力波动对喷嘴内空穴发展影响的CFD分析
The basic mechanism is an air jet supplied by an accurately regulated pressure.
其基本机械结构是一个空气喷嘴，喷嘴压力经过精确调整。
P It consists of the bottom, pressure gauge, handle and nozzle, etc.
警它由底痤、压力表、压把、喷嘴等几部分构成。
A high-velocity fluid stream forced under pressure out of a small-diameter opening or nozzle.
喷射流体在压力迫使下从小喷嘴或小孔中喷出的高速流体
Research on the Atomization Characteristics and Mechanism of Air-blast Nozzles and Development of the CWS Burner for Gasification
气力式喷嘴雾化机理研究及水煤浆气化喷嘴的开发
knapsack sprayer with pressurized cylinder
背负式压力筒喷雾器
atomized spray injectior
(喷注器) 雾化式喷嘴
Experimental Study on Common Rail Accumulator Electronic Control Unit Injector System
共轨蓄压式电控泵喷嘴系统的实验研究
In respect of flexibility of regulating injection characteristics, the electronic unit injector is much better than that of traditional pump-pipe-nozzle system.
而在喷射特性调节的灵活性方面，共轨蓄压式电控泵喷嘴较传统的泵-油管-喷嘴系统有明显改善。
In order to develop a new type of oil supplying system to replace the traditional pump-pipe-nozzle system, the injection characteristics of common rail accumulator electronic unit injector are studied.
研究共轨蓄压式电控泵喷嘴系统的喷射特性，取代传统的泵-油管-喷嘴系统。
Study on the Bottom Hole Pressure Properties of the Oscillating Pulse Jet-Nozzled Bit
振荡脉冲射流喷嘴钻头井底压力特性研究