Analysis and application on rated power curve of chains;
链条额定功率曲线的分析与应用
New method calculating the rated power of V -belt and its programming;
V带传动额定功率计算新方法及其程序设计
Based on the analysis of operation characteristics of the unwind motor, we proved that the calculation of the motor’s maximum current is the key for selecting the motor rated power.
通过对放纸辊电机运行特点的分析,说明在选择电机额定功率时,关键是计算电机的最大负载电流。
A method for matching induction motor rated power of the parallel hybrid electric vehicle based on the vehicle drive cycle was proposed.
提出了基于车辆循环行驶工况并联混合动力汽车感应电机额定功率的匹配方法,在电机过载能力范围内根据每个循环工况电机的需求功率确定常用功率区域和额定功率。
The power rating of a light fixture.
轻型装置器的额定功率
Gross Rear Axle Rating (GRAR)
后轴的总额定功率(GRAR)
afterburner rating
加力燃烧室额定功率
generating station capacity
发电站容量或额定功率
transistor short-pulse power rating
晶体管短脉冲额定功率
V-belt drives-Calculation of power ratings
GB/T11355-1989V带传动额定功率的计算
Calculation of Maxmium Power Rating of Trapezoidal Toothed Synchronizing Belt Drive System
梯形齿同步带传动最大额定功率计算
Definition of the rated output of electric locomotives and motive power units
GB/T3319-1998电力机车和电动车组额定功率的确定
Opinion about Reform Thermal Power Generating Units Ration Power Definition
关于改革火电机组额定功率定义的看法
" Output, voltage and speed ratings of three-phase induction motors (from 0.6 to 100kW)"
GB/T761-1965三相异步电动机额定功率、电压及转速(功率自0.6至100千瓦)
Simulation Analysis of Dynamic Characteristic of Harmonics for High-Speed Locomotive Running at Rated Power
额定功率下高速机车谐波特性的仿真分析
Formulization of Basic Power Rating of Classical V-belt
单根普通V带基本额定功率数表的公式化
Load Factor The load factor is the ratio of the average load to the generator set power rating.
负荷系数负荷系数指的是机组的平均负荷与额定功率之间的比率。
Synchronous belt drives-Calculation of power rating and drive centre distance
GB/T11362-1989同步带传动额定功率和传动中心距的计算
always replace the fuse with the same type and rating
更换保险丝时请务必使用相同的型号和额定功率
Prior to the strict requirements for environmental effects, the total auxiliary power required was approximately 5 %-10 % of generating unit rating.
以前环境要求不严格时,厂用电大约为发电机机组额定功率的5％一10％。
In general, the motor power rating, speed, torque, and details of the regenerative duty cycle need to be known.
一般而言，我们应该清楚电机的额定功率，速度，力矩和具体的制动周期。
carrier power output rating
载波功率输出额定值