Model-predictive-control for an accelerated cooling process
加速冷却过程的模型预测控制
On a Gleeble 1500 hot simulator, the effect of hot deformation and accelerated cooling on the microstructural characteristics of low carbon microalloyed steels were investigated by means of compression tests.
利用 Gleeble- 15 0 0热模拟实验机研究了热变形和加速冷却工艺对 3种低碳微合金钢组织演变的影响。
An important method for producing microalloyed steel plate is controlling the process of accelerated cooling after controlled rolling.
控制钢板轧后的加速冷却工艺是生产微合金化钢板的重要方法 ,在实验的基础上分析了与终轧温度相对应的开冷温度、终冷温度和冷却速度对钢板力学性能的影响。
Influence of Delay Accelerated Cooling on Microstructure and Properties of X100 Pipeline Steel
延迟加速冷却对X100管线钢组织与性能的影响
Flow Characteristic of Undershot Water in ACC System During Flat Hot Rolling
板带钢加速冷却过程中下冲水的流动特性
Application of Advanced Control Technology in Plate Accelerated-cooling Control System
先进控制技术在厚板加速冷却控制系统中的应用
dynamic hardening
快速加热冷却淬火法
INSTALL ADDITIONAL AIR TO OIL TRANSMISSION OIL COOLING CAPACITY.
往油动变速箱油冷却容积内插入附加空气。＊
Study on Ti6Al4V High-speed Machining Mechanism under Different Cooling Conditions
不同冷却润滑条件Ti6Al4V高速加工机理研究
Heavy Ion Synchrotron and Cooler-Storage-Ring in Lanzhou
千兆电子伏重离子加速器——兰州冷却储存环
Data exchange system in cooler-storage-ring virtual accelerator
冷却存储环虚拟加速器的数据交互系统
Water Conductivity Control of Water Cooling System in PET Cyclotron
PET回旋加速器水冷却系统水电导率的控制
Practice and Analysis of Tube Sheet Hardling with High-speed Internal Cooling Shallow Boring
高速内冷却浅孔钻加工管板实践与分析
Numerical simulation and design of cooling system for low-power accelerating tube
低功率加速管冷却系统的数值仿真设计
automatic high speed refrigerated centrifuge
自动高速冷却离心机
critical cooling rate
马氏体临界冷却速度
Transmission-oil cooler
自动变速箱油冷却器
Secondly, we can heat the steel above a certain critical temperature, and then allow it to cool at different rates.
其次，可以把钢加热到某一临界温度以上，然后再让它以不同的冷却速度冷却。
The transformed ferrite volume fraction increases and grain size decreases with the increase of cooling rate.
随着冷却速率的增加,铁素体体积分数减少,晶粒尺寸变细。
HIRFL-CSR Runs into Operation
兰州重离子加速器冷却储存环全面优质建成并投入运行
Analysis and optimal design of heating and cooling process for rapid heating cycle injection mold
快速热循环注塑模具加热与冷却过程分析及其结构优化设计