The new type of single shaft roll cutting shearer is available equipment.
通过对滚切剪工作原理的分析及其结构的改进,指出了新型单轴滚切剪是提高剪切质量的设备。
Gas and steam combined cycle generating unit can be pided into single shaft and multiple shafts combined cycles.
燃气蒸汽联合循环机组可分为单轴和多轴联合循环,本文从设备与投资、占地面积、建设周期、启动停机特征、功率与效率、检修影响以及控制系统等方面分别进行分析,论述了不同轴系配置的优缺点,提出了黄埔电厂宜采用单轴联合循环机组的建议。
This paper comprehensively analyzes and compares the features of single shaft and double shaft layouts in the aspectsof performance, configuration, technical diffculty and development tendency etc.
与超临界及超超临界压力汽轮发电机组容量的大型化密切相关的是单轴与双轴的布置型式。
The steam-gas power ratio of a single-shaft gas-steam combined cycle unit is an important parameter for performance calculation of the entire unit,and it can t be obtained directly from measurement.
单轴燃气-蒸汽联合循环(单轴联合循环)机组蒸汽与燃气功率(蒸燃功)比是整个机组性能计算的重要参数,但无法直接测量得到。
Study on a constitutive model of damage of SFRC under uniaxial compression;
单轴受压状态下钢纤维混凝土损伤本构模型研究
Direct uniaxial tensile experiments with 64 dumbbell shaped specimens were conducted on the MTS810 servo-hydraulic universal machine at strain rate 10~(-5)～10~(-0.
3/s内进行单轴直接拉伸试验,研究了混凝土强度、含水量、应变速率对混凝土直接拉伸特性的影响。
40 concrete specimens were tested on the MTS815 electro-fluid servo-universal machine for uniaxial compressive experiments to study the effect of initial load,the cyclic frequency and the increment of cyclic load amplitude on the compressive properties of concrete.
在MTS815电液伺服岩石试验系统上对40个混凝土圆柱形试件进行了循环荷载作用下的单轴压缩试验。