The relations of support state,stability of support and top coal above the working face, stress condition of four bar linkage with the strength situation of the equilibrium jack were theoretically analyzed and in-situ observed.
采用理论分析及现场实测的方法研究了支架位态、支架稳定性、工作面端面顶煤的稳定性及四连杆受力与平衡千斤顶工作方式及工作阻力之间的关系。
Dynamic analysis and optimization for four-link independent suspension;
四连杆式独立悬架运动学分析与优化
With innovation to its four-link mechanism and ten-line-joint oil pipe a large quantity of spare parts cost saved.
对唐钢第二炼铁厂3#高炉开口机的工作原理及其在工作中存在的问题进行了分析,通过对开口机四连杆机构、十路接头油管的改造,节约了大量的备件费用,具有较好的推广使用价值。
Design on Four-connecting-rod Mechanism for YCK6938H Coach Translational Luggage Compartment Doors;
YCK6938H型客车平移式行李舱门四连杆机构的设计
This paper points out one kind of new type four-connecting-rod self-locking hoist.
本文介绍了一种实用四连杆自锁吊具 ,能有效的解决较大重量的工件起吊。
Dynamic analysis and optimization for four-link independent suspension;
四连杆式独立悬架运动学分析与优化
Researching for Steel Structure Calculation System of Four-bar-type Gantry Crane
四连杆式门座起重机钢结构计算系统研究
Analysis on the Performance of Obstacle Surmounting for Deformabal Tracked Robot With Four Links
四连杆变形履带式机器人的越障性能分析
Variation laws of connecting rod curves for five bar and similar four bar mechanism
类四杆五杆机构连杆曲线的变化规律
A beam that connects the piston rod to the connecting rod of a reciprocating engine.
十字头连接活塞杆和往复式发动机连杆的横杆
reciprocating pitmanless mower
往复式无连杆割草机
aluminum link capsule gun
连杆式铝质弹壳射孔器
parallelogram linkage steering
四边联杆式转向机构
STUDY ON LATERAL BUCKLING OF AN ARCHED LINK OF FOUR BAR LINKAGE
铰链四杆机构圆弧型连杆的侧向失稳分析
Structure Optimization for Hydrostatic Supporting Bush of Crank Shaft and Rod Type Hydraulic Motor
曲轴连杆式液压马达静压支承连杆瓦结构优化
Explains the steps required to design a four bar linkage.
解释设计一个四连杆机构所需的步骤。
MATLAB Simulation Teaching Technique in the Plane Four Links Mechanism;
平面四连杆机构的MATLAB仿真教学法
Brief Introduction to New Four-bar Self-locking Hoist;
一种实用四连杆自锁吊具的设计简介
Analysis of reed-base′s front extreme position for four-bar beating-up linkage
四连杆打纬机构的筘座前心位置分析
Optimize and Design for the Four-Link Structure of the Die Bonder and Motion Simulation Based on the CosmosMotion
基于CosmosMotion的焊头四连杆机构优化设计
Optimal Design of Four-bar Mechanism in Hydraulic Support Based on Scilab
基于Scilab的液压支架四连杆优化设计
Kinematical Analysis of a Four-bar Mechanism Using MATLAB
基于MATLAB的四连杆机构运动分析
Dynamic Simulation of a Four Bar Mechanism with Clearance in Linkage-Rocker Joint based On Virtual Prototyping Technology;
含连杆摇杆运动副间隙四杆机构动力学仿真研究