Optimization of crank camshaft on low-fluctuation reciprocating triplex pump;
低波动三缸单作用往复泵曲拐凸轮轴优化设计
Automotive crank signal interference, which can cause engine stall at normal condition, mainly comes from engine ignition system.
汽车曲轴信号的干扰可能导致发动机熄火,曲轴信号电磁干扰主要来自发动机点火系统。
Application of Shielded Cable in Electromagnetic Interference Suppression for Automotive Crank Signals
屏蔽线在汽车曲轴信号电磁干扰抑制中的应用
Crank Position Sensor Sig
曲轴位置感知器信号
Design of the crankshaft pulley signal plate dedicated CNC milling machine
曲轴皮带轮信号盘数控铣齿专机设计
Bispectrum Analysis for Vibration Data of Crankshaft Bearing in Diesel Engine
柴油发动机曲轴轴承振动信号的双谱分析
Design of Signal Simulator for Crankshaft Position Sensor
基于CPLD的曲轴位置传感器信号仿真器设计
Analysis of the Vibration Signals of the Diesel Engine's Crank-Shaft Bearing Based on Higher Order Cyclostationarity
基于高阶循环平稳的柴油发动机曲轴轴承振动信号分析
A Crankshaft Fluctuation Sensor (CKF) is located near the bottom of the timing cover where it generates a signal as the crankshaft timing chain sprocket rotates past it.
曲轴位置传感器安装在定时器壳底部附近，产生一个曲轴定时链轮齿通过的信号。
These sensors establish ignition and fuel injection timing, and monitor crankshaft speed variation.
这些传感器（的信号）来对点火、燃油喷射定时和曲轴速度变化监控。
New Virtual Instrument Monitoring Power Condition of ICE Based on AngularVibration of Crankshaft
基于曲轴角振动信号的多缸内燃机作功状态监测仪
The Key Technology Study on Fault Diagnosis System of I.C. Engine Based on Angular Vibration of Crankshaft;
基于曲轴角振动信号的内燃机故障诊断系统关键技术研究
Study on Fault Diagnosis System of I.C. Engine Based on Angular Vibration of Crankshaft;
基于曲轴角振动信号的内燃机故障诊断系统研究
Design of the Fault Diagnosis Instrument for I.C.Engine Based on AVR Controlled and Signal of Crankshaft Angular Vibration;
基于AVR单片机和曲轴角振动信号的内燃机诊断仪研制
gyro output-axis pick-up
陀螺输出轴信号传感器
capstan tachogenerator signal
主导轴转速传感信号
light-signal transfer characteristic
光信号转换特性曲线
crank angle signal sender
曲柄转角信号发送器
Crank Pos Sensor Sig
曲柄位置感知器信号
crankshaft (main journal turning lathe)
曲轴（主轴颈）车床