This text introduced features、principle、technological method of airless spraying and equipment of painting.
无气喷涂是应用最广泛的涂装方法之一。
The main influential factors against bubble forming during emulsion paint airless spraying application are analyed.
本文分析了乳胶漆无气喷涂施工中微泡形成的主要影响因素,通过改变乳胶漆的配方达到控制减少喷涂过程中微泡的产生。
In the second part, process condition, operational gist and process characteristic of container airless spraying, container film s drying and curing were discussed.
文章第二部分讨论了集装箱无气喷涂工艺条件、操作要点和自动喷漆工艺特点,以及集装箱涂膜的干燥与固化。
The merits of airless spray are introduced.
介绍了无气喷涂的优点及其专用喷嘴的选择依据、方法和参数。
Spaying governs in this coating sequence, and rolling painting as complementary.
本工程的油漆涂装方法以高压无气喷涂为主，滚涂为辅。
Spraying method whether by air spray, airless spray, hot air spray or hot airless spray should be in accordance with the following.
空气喷涂，无空气喷涂，热空气喷涂或无空气热喷涂均应遵循以下原则。
high pressure airless heating pasted type spraying machine
高压无空气加热厚浆型涂料喷涂机
Development of Cold Gas Dynamic Sprayed Al-Pb Alloy Coatings;
冷气动力喷涂Al-Pb合金涂层的研究
Microstructure characteristics of supersonic cold gas spray coatings
超音速冷气体动力喷涂的涂层微结构
Powder flame spray or spray fusing gun can be used with inert gas to feed powder with best coating effects,and can also be used for spary of ceramic powder.
粉末火焰喷涂喷焊设备。用惰性气体送粉，能得到更佳涂层品质，也可喷涂氧化物涂层。
Study on the Process and the Properties of Atmospheric Plasmasprayed 7wt.%Y_2O_3-ZrO_2 Coating
大气等离子喷涂7wt.%Y_2O_3-ZrO_2涂层的工艺及性能研究
High Temperature Oxidation Behavior of APS Thermal Barrier Coatings
大气等离子喷涂热障涂层高温氧化行为研究
Properties and Application of WC Coating Prepared by High Velocity Air Fuel
空气助燃超音速火焰喷涂WC涂层的性能及应用
Thermal spraying coating Nondestructive methods for measurement of thickness
GB/T11374-1989热喷涂涂层厚度的无损测量方法
Study on Ultrasonic NDT Method of the Thickness of Coated Layer in Thermal Spraying;
热喷涂涂层厚度的超声无损检测方法研究
with heat-resistant, non-poisonous and non-tacky coating on its inner surface and with non-poisonous and acid and alkali-resistant coating of brilliant color on its outer surface.
内表面喷涂耐高温、无毒、无粘性的涂层,外表面喷色泽鲜明的涂料,既耐酸、耐碱又无毒性。
The coatings are sprayed onto the components being analyzed by using aerosol cans or compressed-air spray guns.
涂料是用按钮喷雾罐或压缩气喷枪喷到所要分析的零件上去的。
solid injection diesel engine
无气喷射柴油发动机
Gas-particle Two Phase Flow in Supersonic Cold Gas Dynamic Spray;
超音速冷气体动力喷涂过程中的气固两相流动
airless injection engine
无气喷射式发动机，机械喷油式发动机
Effect of H_2 flow rate on electrical conductivity of APS TiO_2 coatings
氢气流量对大气等离子喷涂TiO_2涂层导电性的影响
The numerical simulating of the supersonic gas-particle two phase flow in De-Laval-Nozzle;
冷气体动力喷涂喷管内超音速气固两相流动数值模拟