A novel three-phase three-level neutral-pointclamped switching mode PWM rectifier is presented,the mathematical model of the rectifier is analyzed in details,and the working mode and the control method are studied in detail.
针对一种新型的三相三电平中性点箝位开关模式PWM整流电路拓扑,详细分析了其数学模型,并对该PWM整流器的工作模式及其控制方法进行了深入研究。
A novel two-arm asymmetry three-level neutral-point-clamped switching mode PWM rectifier is proposed, the mathematical model of the rectifier is derived, and the working mode and the constant- frequency PWM control method are analyzed in detail.
该文提出一种新型的两桥臂非对称三电平中性点箝位开关模式PWM整流电路拓扑,详细分析了其数学模型,深入研究了该PWM整流器的工作模式及其恒频PWM控制方法。
Based on the effective switch modes of MC,the producing principle of common-mode voltage is analyzed and discussed.
基于矩阵变换器有效开关模式,分析了矩阵变换器供电时电机共模电压的产生机理,结果表明:采用空间矢量调制方法时,共模电压的最大峰值与零矢量的开关状态有关。
Experimental result showed that switch mode determined by hardware could reduce work load of software of microprocessor in induction motor control system,reduce frequency of power switch,and cut down wastage of switch.
实验结果表明,由硬件决定开关模式在感应电动机控制系统中可以大大降低微处理器的软件工作量,降低功率开关器件的频率,减少开关损耗。
Absolute/Relative Snap Toggle Mode
绝对/相对捕捉开关模式
Research to Reduce EMI of SMPS Based on Chaotic Switching Modulation Technique;
混沌开关调制技术降低开关模式电源EMI水平研究
AutoKey Mode Toggle
自动关键帧模式开关
Box Mode Selected Toggle
被选择的物体模式开关
Shade Selected Mode Toggle
着色选择集模式开关
Research on the Modules of Current Mode Switching Power Supply Controll IC;
电流模式开关电源控制IC相关模块的研究
Mode switch. This control is used to select the desired transmit mode. The modes available are:
模式开关,这个控制旋钮能选择你要求的发射模式,可选模式有:。
Faulty heater-A/C mode control switch
加热器-空调模式控制开关有故障
Design of Average Current Mode PWM Buck Switching Power Supplies;
平均电流模式PWM降压开关电源设计
Design of PWM DC-DC Buck Switching Converter Based on Current-mode Technology;
一种电流模式控制PWM开关电源的设计
Research on Current-mode PWM Switching Power Supply Chip;
电流模式PWM开关电源芯片的研究
Development of a Green Mode Switching Power Supply
一种绿色模式开关电源的研究与设计
Development patterns and key techniques of coal-formed Kela 2 gas field
克拉2煤成大气田开发模式与开发关键技术
The research and design of the lotiform open-close mould CAD system
荷花开式开关模机构CAD系统的设计研究
Design of Multi-Mode Quasi-Resonant Fly-back Switching Power Supply Controller;
多模式准谐振反激式开关电源控制器设计
Modeling and Design of Monolithic Switching Regulator in Current-Mode;
电流控制模式单片开关电源的建模与设计
Full-Order Nonlinear Models and Simulation of Boost Converters Operating in DCM
DCM模式Boost开关变换器的非线性全阶建模和仿真
Open site diagrams must be closed to switch modes.
打开的站点关系图必须关闭才能切换模式。