Influence of axial deformation and floor distortion on behaviors of hybrid structure;
轴向变形与楼板变形对混合结构受力性能的影响
Building of test system on axial deformation of diamond circular saw blade
金刚石圆锯片轴向变形测试系统的构建与实验研究
The change of temperature after or before gas well put into production will result in the variation of tubing string stress and axial deformation.
气井投产前后温度和压力变化会引起油管应力及轴向变形的改变。
Study of dynamic pore water pressure and axial strain in saturated sand-gravel composites;
饱和砂砾料振动孔压与轴向应变发展模式研究
A new type of test method called multi-spots axial strain sensor was elaborated,the development conception and test principle were also introduced.
以钢筋混凝土简支梁正截面实验教学为例,分析了钢筋混凝土梁、柱轴向应变常用测试方法和存在问题;论述了钢筋混凝土梁柱多点轴向位移式应变仪的研制思路、测试原理;比较了各种轴向应变测试方法的优缺点。
Then,the sand liquefaction process is pided into four phases according to the different behavior of hysteresis loop,during which the development characteristics of axial strain are analyzed.
结合应力_应变滞回环,将液化过程划分为4个阶段,并对各阶段的轴向应变发展特点进行了分析。
The most important of the results is the finding of significant axial variations of the combustion parameters.
最重要的结果是燃烧参数的轴向变化显著。
Analysis on properties of vertical stress-stain of six solidified saline soils inshore
六种固化滨海盐渍土的轴向应力应变特征
Study on axial length changing and its controlling during heat treatment of 440C steel tube
440C钢管热处理轴向尺寸变化规律与工艺控制
coaxial variable direction coupler
同轴可变定向耦合器
The effect of radial load to radial stiffness can be neglected.
径向载荷的变化对轴承径向刚度的影响可以忽略.
Specification: direction of rotation of output shaft varies with that of input shaft.
说明：当输入轴旋转方向改变，输出轴相应改变。
the shape, run and change trend of shaft center trajectory are consistent to the test result too.
轴心轨迹的形态、走向及变化趋势与实验结果相吻合。
The Significance and the Expression Changes of Slit-2 during the Spinal Cord Injury of Rats;
大鼠脊髓损伤后轴突导向因子slit-2的表达变化及意义
Dynamic display of the rotation of display elements about an axis the orientation of which is continuously changing in space.
显示元素相对于一个轴旋转的动态显示过程，此轴在空间的方向是连续不断地变化的。
Analysis of Axial Velocity With Perspective Affine Transformation
轴向变形系数的透视仿射变换法分析
Axial load-deformation curve and preload on angular con act ball bearings
角接触球轴承的轴向载荷—变形曲线和预紧
Introducing The Coefficient of Asle Direction Changed Shape andthe Size of Angle Between Axle and Asle From the Formation of Posi-tive Equal AnoprojEction
从正等轴测图形成过程分析轴向变形系数和轴间角的大小
This accommodates any effective change of length of the propeller shaft as the rear axles move toward or away from the car frame.
当后桥在车架上向前或向上运动时,这种结构足以调整传动轴长度的任何变化。
By transverse exposure, periodical modulation of refractive index is formed along the axis of optical fiber.
制备原理是对光纤横向曝光，使光纤的折射率指数在轴向发生周期性变化。
There must be one or more universal joints to permit variations in the angle of drive. There must also be a slip joint that permits the effective length of the propeller shaft to change.
一个或几个万向节来适应传动角度的变化;一套伸缩花键,能够改变传动轴的现有长度。
Axial forces in the three working rollers reaches maximum at startup.
三个工作轮的轴向力随着变矩器的工况变化，在起动工况时达到最大值。
Neglect the axial deformations and consider only the lumped masses.
略去轴向变形不计，仅考虑集中质量。
CALCULATION OF SHEARING STRESS FOR AXIAL DRAWING OF TRANSFORM SECTION BAR
变截面直杆轴向拉伸时的剪应力计算