Effects of sintering temperature on fatigue damage of alumina ceramics;
烧结温度对氧化铝陶瓷疲劳损伤过程的影响
Effect of sintering temperature on contexture and performance of iron-based P/M aircraft brake materials;
烧结温度对铁基粉末冶金航空刹车材料组织的影响
Effect of sintering temperature on microstructure and mechanical property of ceramic corundum abrasives;
烧结温度对陶瓷刚玉磨料性能的影响
07%the sinter temperature of magnet reaches 1110 ℃with no abnormal grain growth and coercivity reaches 1021 kA/m and the addition of Nb benefits the squareness of magnet;When the addition of Nb and Zr both reach 0.
07%,磁体烧结温度可达到1110 C,晶粒不发生异常长大,矫顽力达到1021kA/m,Nb的添加对提高磁体的方形度有利。
The microcosmic structure and radiant performance of transition metal oxides radiant powder basic material with main component of Fe_2O_3 under different sinter temperature were introduced.
本文介绍了不同温度下烧结的以 Fe_2O_3为主要成分的过渡金属氧化物辐射材料的微观结构与辐射性能,分析了烧结温度对其矿物组成、微观结构及辐射性能的影响关系,探讨了改善 Fe_2O_3基辐射材料红外辐射性能的掺杂方式。
07at%, the sinter temperature of magnet could reach to 1110 ℃ with no abnormal grain growth, and coercivity increased to 1021 kA/m.
07%,磁体的烧结温度可高达1110℃,晶粒不发生异常长大,矫顽力达到1021kA/m左右,Nb的添加提高了磁体的方形度。
It s firing temperature is 1300℃-1450℃,and firing time is 3 hours .
用SrCO3 、Al2 O3 、Eu2 O3 和Dy2 O3 烧制SrAl2 O4:Eu2 + ,Dy3 + 长余辉光致发光陶瓷 ,其烧结温度为 1 30 0℃— 1 4 0 0℃ ,烧结时间为 3小时。
When the powder was mixed with BaCO 3, its firing temperature was 180～250℃ lower than that by the conventional mixed oxide method.
结果表明：当ｏｘｉｎｅ的加入量大于ＭｇＴａ２Ｏ６摩尔数的３倍，ｐＨ值保持在１０左右时制得的钽镁粉料较为理想，其比表面积达３２ｍ２／ｇ，与ＢａＣＯ３混合后烧结温度比用传统制备法降低１８０～２５０℃。
Much more fly ash(FA)be mixed into fired body to save earth and energy,make use of waste,and protect environments,and this couses some process problems as well,because FA features incohesive grain,being barren,high firing temperature.
提高粉煤灰在烧结坯体中的掺量,虽然对节土、节能、利废、环保等方面的意义重大,但由于粉煤灰颗粒松散,瘠性强,烧结温度高等方面的特点,必然带来生产工艺方面的问题。
Study on sintered temperature and performance of nickel base cathode LiNi_(0.90)Co_(0.05)Mn_(0.05)O_2 coated with Co and Mn components;
Co、Mn包覆镍基材料LiNi_(0.90)Co_(0.05)Mn_(0.05)O_2的烧结温度与性能研究
The reason of needle pore existed in the membrane was analyzed;the effects factors of different thickness of stainless steel membrane were discussed;and sintered temperature about for powders with various powder size was researched.
采用离心涂敷的方法制备非对称不锈钢分离膜,研究在制备过程中针孔产生的原因,讨论了膜层厚度的影响因素,探索不同粒度的粉末烧结温度,制备出具有高精度、大流量的非对称不锈钢分离膜。
At same sintered temperature, more holes occurred in the HA coating in the case of pH=0.
结果表明,相同烧结温度下,pH=0。
It was found that the partial melting temperature and solid phase sintering temperature parameters during heat treatment strongly influence the phase for- mation of Bi–2212.
在热处理过程中,局部熔化温度和固相烧结温度对Bi–2212相的形成起关键作用。
Effects of Sintering Temperature on Microstructure and Performances of Micro-Porous Si_3N_4 Ceramics
烧结温度对Si_3N_4显微结构及性能的影响
Effect of sintering temperature on properties of Sr_2Bi_4Ti_5O_(18) ferroelectric ceramics
烧结温度对Sr_2Bi_4Ti_5O_(18)铁电陶瓷性能的影响
Effect of reactive sintering temperature on properties of Si_3N_4-SiC refractories
反应烧结温度对Si_3N_4-SiC材料性能的影响
Effect of sintering temperature on the structure and properties of ternary boride hard alloys
烧结温度对Mo_2FeB_2合金组织性能的影响
Effect of Sintering Temperature on Dielectric Properties of BaCu_3Ti_4O_(12)
烧结温度对BaCu_3Ti_4O_(12)介电性能的影响
THE EXPERIMENTAL RESEARCH ON SINTERING TEMPERATURE TO Fe_2O_3 POWDER SINTERING DENSITY
烧结温度等参数对Fe_2O_3粉末烧结密度影响的试验研究
Effect of sintering temperature on phase composition and microstructure of Y_2Ba_4CuNbO_x powder
烧结温度对Y_2Ba_4CuNbO_x粉体物相成分及显微结构的影响
Effects of sintering temperature on mechanical properties and microstructure of WZV material
烧结温度对WZV材料力学性能和显微结构的影响
Effect of sintering temperature on microstructure and properties of porous titanium
烧结温度对多孔钛组织结构与性能的影响
The effect of the additives and its amount on the densification of BN-ZrO?2 composite powder body during hot pressing sintering were investigated.
研究了烧结助剂和添加量及烧结温度对氮化硼、化锆复合粉体在热压烧结过程致密化的影响。
Progresses in the Low Sintering Temperature Microwave Dielectric Ceramics;
固有烧结温度低的微波介质陶瓷研究进展
Effects of V_2O_5 content and sintering temperature on magnetic properties of Mn-Zn ferrites
V_2O_5含量与烧结温度对MnZn铁氧体性能的影响
Effect of sintering temperature and time on electrochemical performance of Li_4Ti_5O_(12)
烧结温度和时间对Li_4Ti_5O_(12)电化学性能的影响
Influence of the Sintering Temperature on the Dielectric and Ferroelectric Properties of Bi_(0.7)Ba_(0.3)FeO_3 Ceramics
烧结温度对Bi_(0.7)Ba_(0.3)FeO_3陶瓷介电、铁电特性影响
Li-BASED MICROWAVE DIELECTRIC CERAMIC MATERIALS WITH LOW INTRINSIC SINTERING TEMPERATURES
固有烧结温度低的Li基微波介质陶瓷材料
The Mathematics Model of LTCC Sintering Furnace Temperature Field
低温共烧陶瓷专用烧结炉温度场的数学模型
STUDY ON MICROSTRUCTURE OF ELECTRICAL PORCELAIN AT DIFFERENT SINTERING TEMPERATURES
不同烧成温度下电瓷微观结构的研究
DYNAMIC DISTRIBUTION SIMULATION OF TEMPERATURE FIELD IN CERAMIC HOT-PRESS SINTERING FURNACE
陶瓷热压烧结炉温度场动态分布模拟