1.Possible. The part is very long and thin, very easy to be deformed ( warpage). Please inform customer about this.
很有可能会变形。产品又长又薄，很容易变形。需告诉诉客户这事。
2.Thus, the semi-insulating nitride semiconductor crystal substrate in which warpage is less and cracking is less likely can be obtained.
由此，能获得其中翘曲较少且较不可能发生破裂的半绝缘氮化物半导体晶体衬底。
3.c. Mold stress relief : No shrinkage, warpage or other distortion to interfere normal operations or reduce electrical spacing.
残留应力：不会缩收、扭曲或其它变形而影响原有之特性或降低绝缘距离。
4.This indicates that the developed ANN model has good interpolation capability and can be used as an efficient predictive tool for warpage.
这表明ANN模型具有良好的插值能力，可作为一种对于翘曲预测的有效工具。
5.If this causes a warpage problem, it sometimes helps to raise the overall water temperature and slow the rate of heat transfer.
如果这样还有翘曲问题，那么升高总的水温并降低热交换速度是有益的。
6.It is revealed that the optimal method is able to effectively reduce plastic part warpage.
结果显示各最佳化方法均能有效降低塑件翘曲；
7.Through comparing the important simulating results about the weld lines, warpage deformation, sink marks, the best gating is received.
并通过比较不同方案下的熔接线、翘曲变形、缩痕指数等重要结果，得出了最佳的浇注系统设计方案。
8.In the micro-featured injection molding process, mold temperature would directly affect the shrinkage, warpage and residual stress.
具微结构与微特徵尺寸产品的射出成型制程中，模具温度控制会直接影响产品的收缩、翘曲与残留应力。
9.significantly improves part quality in warpage, roundness, flatness and dimensional stability, reduces molded-in stress MuCell?
可改善产品的翘曲，同心度，平面度及尺寸的稳定性和产品内应力。
10.GUO ZH Y. Numeric simulation and experiment research on warpage and deformation of injection molding part. [D].
郭志英。注射制品翘曲变形数字模拟及试验研究[D]。华中科技大学，2001。