1.Steel for carburizing is usually a low-carbon steel of about 0. 15% carbon that would not in itself responds appreciably to heat treatment.
用于渗碳的一般是含碳量约为0.15%、本身不太适合热处理的低碳钢。
2.Carry out a research into the application of bipolar thyristor to the carburizing furnace control system.
对双向晶闸管在渗碳炉控制系统中的应用进行了研究。
3.CYCLE TIME : Amount of time product spends in a furnace at specified temperature for the purpose of carburizing or hardening product.
周期：产品在炉中某特定温度下渗碳或硬化所需要的时间。
4.The feature of the microstructure of the silicon- aluminizing coating and its anti-carburizing property were analyzed and studied.
分析了铝硅共渗层的组织特点，研究了处理层的抗渗碳性能。
5.The amount and the depth of carburizing on the casting surface can be obtained approximately by a calculating formula.
给出了铸件表面增碳大小及增碳层深度的近似计算公式。
6.Low temperature plasma carburizing is an effective process of improving mechanical property of austenitic stainless steel.
低温离子渗碳处理是一种能改善奥氏体不锈钢表面力学性能的有效方法。
7.Carburizing, cyaniding, and induction hardening are some of the processes commonly used to produce the case hardening effect.
碳化、氰化、感应淬火是局部淬火中经常使用的处理方法。
8.The carburization rate can be increased 20% compared with the conventional carburization process by using RE catalyzed carburizing.
采用改进型稀土催渗剂进行渗碳后，与常规渗碳工艺相比提高渗碳速度20%；
9.Meanwhile the carburizing speed is increased, the metallurgical structure is improved, the satisfactory results are obtained.
同时提高渗速、改善金相组织，取得满意效果。
10.The better technological process now is the step control of carbon potential during carburizing .
目前最佳渗碳工艺方法，是在整个渗碳过程中对碳势进行台阶式控制。