on the maximum pressure of current rush to air mass.
从理论上研究了阀门前充水段长度、滞留气团的初始长度、多方指数n等参数对输水管道水流冲击气团最大压力的影响。
Finite element analysis of maximum rolling pressure of rotary roll forming for straight tooth bevel gear;
直齿圆锥齿轮摆辗成形最大辗压力的有限元研究
This article makes a theoretical analysis of the air current at the back sheet of a card and propose the concept of gauge ratio,assuming that at the back sheet exists a maximum pressure point whose location is related with gauge ratio,pressure difference,exit gauge and back sheet length.
对梳棉机后罩板处的气流理论进行分析,提出隔距比的概念,认为后罩板处有一压力最大处,其位置与隔距比、压力差、出口隔距及后罩板长度有关;同时对梳棉机后罩板处的研究现状进行了归纳和总结,认为单独加装棉网清洁器对成纱质量是有利的,风量以180~240 m3/h为佳,单独加装固定盖板对成纱质量也是有利的,隔距应偏大掌握,且根数不宜过多,固定盖板与棉网清洁器配合使用,效果更佳,并提出其安装位置在后罩板压力最大处为宜。
Taking the MATLAB as an auxiliary tool,the optimization designing method for basic dimensions of the disk cam mechanism with translation push rod while the push rod realizes the regular basic movement was presented,thus letting the volume of cam mechanism and the maximum pressure angle reached a minimum.
以MATLAB为辅助工具,给出了直动推杆盘形凸轮机构在推杆实现规律的基本运动时的基本尺寸优化设计方法,使凸轮机构的体积和最大压力角达到最小。
A method for optimizing the main dimensions of a cam-oscillating follower mechanism in common follower motions is presented with the MATLAB,which maximizes the cam volume and maximum pressure angles.
以MATLAB为辅助工具,给出了摆动推杆盘形凸轮机构在基本推杆运动规律时的基本尺寸优化设计方法,使凸轮机构的体积和最大压力角达到最小。
Analysis and research were made for relation about max external pressure resisting capacity under condition of different ratio between straight section length and end arc radius on the flatted tubes with same circumference and tube wall thickness by using analytical technology of finite element.
应用有限元分析方法,对相同周长、相同壁厚的扁管在直边段和圆弧半径的不同比值条件下与所能承受最大外压力的关系进行了分析。
the ratio of the breaking stress of a structure to the estimated maximum stress in ordinary use.
间断压力同最大压力的比率。
The Effect of Maximal Pressure and Roll-gap on Energy Consumption of Roller Press
最大压力与辊隙对辊压机能耗的影响
Determination for maximum explosion and maximum rate of pressure rise of dust cloud
GB/T16426-1996粉尘云最大爆炸压力和最大压力上升速率测定方法
(2) For closed vessels with spherical shape, the bigger volume of vessel is, the smaller ascent rate of pressure becomes, and the volume of vessel has no effect on the maximum explosion pressure.
容器的容积越大，最大压力上升速率就越小； 容器的容积对最大爆炸压力没有影响。
maximum allowable working pressure
最大容许工作压力;最大允许工作压力;最高允许工作压力
maximum penetration load of ripper
松土器的最大推压力
maximum working pressure of blowout preventer
防喷器最大工作压力
permissible mean maximum pressure
容许的最大平均压力
maximum penetration load of blade
推土铲的最大推压力
maximum knock-out stroke
(压力机的) 最大打料行程
The lowermost capillary fringe is a zone in which the pressure is less than atmospheric.
最下面的那个毛细水带中的压力小于大气压。
Research on Measuring Method of Maximum Cylinder Compression Pressure for Multi-cylinder Diesel Engine
多缸柴油机最大气缸压缩压力测试方法研究
Calculate the pressure difference by subtracting the desired outlet pressure from the maximum inlet pressure.
通过从最大进口压力减去所需要的出口压力来计算压差。
The maximum value, i. e. at the blast wave (or shock) front, is called the "peak overpressure."
位于冲击波波阵面上的最大超压值称为“最高超压力。”
Research on Maximum Speed Capacity and thePlantar Pressure Character of Race Walking Event
竞走项目最大速度能力和足底压力特征研究
maximum output pressure(absolute)
(绝) 最高排出压力
Each hot water space heating boiler shall be equipped with a pressure relief valve set to relieve below the maximum boiler working pressure.
每个热水供暖锅炉都必须配置压力安全阀,其设置的泄压压力必须小于锅炉的最大工作压力。
Essentially balanced single seat minimizes a variation in delivery pressure resulting from a varying inlet pressure.
基本平衡单阀座最大限度减小进口压力变化对输出压力的影响。