cyclopentadienylmolybdenum (v) tetrachloride

物化性质

存储条件/存储方法：

存放在充有干爽惰性气体的容器内，并放在阴凉，干爽处。储存的地方必须上锁，钥匙必须交给技术专家和他们的助手保管。避免湿气和水分。远离氧化剂。

稳定性相关：

远离氧化物，水分/潮湿。

其它信息：

1. 性状：深红色粉末。

2. 密度（g/mL,25/4℃）：未确定

3. 相对蒸汽密度（g/mL,空气=1）：未确定

4. 熔点（ºC）：未确定

5. 沸点（ºC,常压）：未确定

6. 沸点（ºC,5.2kPa）：未确定

7. 折射率：未确定

8. 闪点（ºC）：未确定

9. 比旋光度（º）：未确定

10. 自燃点或引燃温度（ºC）：未确定

11. 蒸气压（kPa,25ºC）：未确定

12. 饱和蒸气压（kPa,60ºC）：未确定

13. 燃烧热（KJ/mol）：未确定

14. 临界温度（ºC）：未确定

15. 临界压力（KPa）：未确定

16. 油水（辛醇/水）分配系数的对数值：未确定

17. 爆炸上限（%,V/V）：未确定

18. 爆炸下限（%,V/V）：未确定

19. 溶解性：与水反应长生HCl。

安全信息

存储条件/存储方法：

存放在充有干爽惰性气体的容器内，并放在阴凉，干爽处。储存的地方必须上锁，钥匙必须交给技术专家和他们的助手保管。避免湿气和水分。远离氧化剂。

稳定性相关：

远离氧化物，水分/潮湿。

其它信息：

1. 性状：深红色粉末。

2. 密度（g/mL,25/4℃）：未确定

3. 相对蒸汽密度（g/mL,空气=1）：未确定

4. 熔点（ºC）：未确定

5. 沸点（ºC,常压）：未确定

6. 沸点（ºC,5.2kPa）：未确定

7. 折射率：未确定

8. 闪点（ºC）：未确定

9. 比旋光度（º）：未确定

10. 自燃点或引燃温度（ºC）：未确定

11. 蒸气压（kPa,25ºC）：未确定

12. 饱和蒸气压（kPa,60ºC）：未确定

13. 燃烧热（KJ/mol）：未确定

14. 临界温度（ºC）：未确定

15. 临界压力（KPa）：未确定

16. 油水（辛醇/水）分配系数的对数值：未确定

17. 爆炸上限（%,V/V）：未确定

18. 爆炸下限（%,V/V）：未确定

19. 溶解性：与水反应长生HCl。

毒理性

生态数据：

对水稍微有危害的，不要让未稀释或者大量产品接触地下水，水道或者污水系统。若无政府许可，勿将材料排入周围环境。

MSDS

Section1. IDENTIFICATION OF THE SUBSTANCE/MIXTURE
Product identifiers
Product name: Cyclopentadienylmolybdenum(V) tetrachloride
CAS-No.: 62927-99-5
Relevant identified uses of the substance or mixture and uses advised against
Identified uses: Laboratory chemicals, Manufacture of substances


Section2. HAZARDS IDENTIFICATION
Classification of the substance or mixture
Classification according to Regulation (EC) No 1272/2008 [EU-GHS/CLP]
Skin corrosion (Category 1B)
Classification according to EU Directives 67/548/EEC or 1999/45/EC
Causes burns.
Label elements
Labelling according Regulation (EC) No 1272/2008 [CLP]
Pictogram
Signal wordDanger
Hazard statement(s)
H314Causes severe skin burns and eye damage.
Precautionary statement(s)
P280Wear protective gloves/ protective clothing/ eye protection/ face
protection.
P305 + P351 + P338IF IN EYES: Rinse cautiously with water for several minutes. Remove
contact lenses, if present and easy to do. Continue rinsing.
P310Immediately call a POISON CENTER or doctor/ physician.
Supplemental Hazardnone
Statements
According to European Directive 67/548/EEC as amended.
Hazard symbol(s)
R-phrase(s)
R34Causes burns.
S-phrase(s)
S26In case of contact with eyes, rinse immediately with plenty of water and
seek medical advice.
S36/37/39Wear suitable protective clothing, gloves and eye/face protection.
S45In case of accident or if you feel unwell, seek medical advice immediately
(show the label where possible).
Other hazards - none
Section3. COMPOSITION/INFORMATION ON INGREDIENTS
Substances
Formula: C5H5Cl4Mo
Molecular Weight: 302,85 g/mol
ComponentConcentration
Cyclopentadienylmolybdenum(V) tetrachloride
CAS-No.62927-99-5-
Section4. FIRST AID MEASURES
Description of first aid measures
General advice
Consult a physician. Show this safety data sheet to the doctor in attendance.
If inhaled
If breathed in, move person into fresh air. If not breathing, give artificial respiration. Consult a physician.
In case of skin contact
Take off contaminated clothing and shoes immediately. Wash off with soap and plenty of water. Consult a
physician.
In case of eye contact
Rinse thoroughly with plenty of water for at least 15 minutes and consult a physician.
If swallowed
Do NOT induce vomiting. Never give anything by mouth to an unconscious person. Rinse mouth with
water. Consult a physician.
Most important symptoms and effects, both acute and delayed
To the best of our knowledge, the chemical, physical, and toxicological properties have not been
thoroughly investigated.
Indication of any immediate medical attention and special treatment needed
no data available
Section5. FIREFIGHTING MEASURES
Extinguishing media
Suitable extinguishing media
Use water spray, alcohol-resistant foam, dry chemical or carbon dioxide.
Special hazards arising from the substance or mixture
no data available
Advice for firefighters
Wear self contained breathing apparatus for fire fighting if necessary.
Further information
no data available
Section6. ACCIDENTAL RELEASE MEASURES
Personal precautions, protective equipment and emergency procedures
Use personal protective equipment. Avoid dust formation. Avoid breathing vapors, mist or gas. Ensure
adequate ventilation. Evacuate personnel to safe areas. Avoid breathing dust.
Environmental precautions
Do not let product enter drains.
Methods and materials for containment and cleaning up
Pick up and arrange disposal without creating dust. Sweep up and shovel. Keep in suitable, closed
containers for disposal.
Reference to other sections
For disposal see section 13.
Section7. HANDLING AND STORAGE
Precautions for safe handling
Avoid formation of dust and aerosols.
Provide appropriate exhaust ventilation at places where dust is formed.
Conditions for safe storage, including any incompatibilities
Store in cool place. Keep container tightly closed in a dry and well-ventilated place.
Moisture sensitive.
Specific end uses
no data available
Section8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Control parameters
Components with workplace control parameters
Exposure controls
Appropriate engineering controls
Handle in accordance with good industrial hygiene and safety practice. Wash hands before breaks and
at the end of workday.
Personal protective equipment
Eye/face protection
Face shield and safety glasses Use equipment for eye protection tested and approved under
appropriate government standards such as NIOSH (US) or EN 166(EU).
Skin protection
Handle with gloves. Gloves must be inspected prior to use. Use proper glove removal technique
(without touching glove's outer surface) to avoid skin contact with this product. Dispose of
contaminated gloves after use in accordance with applicable laws and good laboratory practices.
Wash and dry hands.
The selected protective gloves have to satisfy the specifications of EU Directive 89/686/EEC and
the standard EN 374 derived from it.
Body Protection
Complete suit protecting against chemicals, The type of protective equipment must be selected
according to the concentration and amount of the dangerous substance at the specific workplace.
Respiratory protection
Where risk assessment shows air-purifying respirators are appropriate use a full-face particle
respirator type N100 (US) or type P3 (EN 143) respirator cartridges as a backup to engineering
controls. If the respirator is the sole means of protection, use a full-face supplied air respirator. Use
respirators and components tested and approved under appropriate government standards such
as NIOSH (US) or CEN (EU).
Section9. PHYSICAL AND CHEMICAL PROPERTIES
Information on basic physical and chemical properties
a) AppearanceForm: solid
b) Odourno data available
c) Odour Thresholdno data available
d) pHno data available
e) Melting point/freezingMelting point/range: 245 - 249 °C - dec.
point
f) Initial boiling point and no data available
boiling range
g) Flash pointno data available
h) Evaporation rateno data available
i) Flammability (solid, gas) no data available
j) Upper/lowerno data available
flammability or
explosive limits
k) Vapour pressureno data available
l) Vapour density10,46 - (Air = 1.0)
m) Relative densityno data available
n) Water solubilityno data available
o) Partition coefficient: n- no data available
octanol/water
p) Autoignitionno data available
temperature
q) Decompositionno data available
temperature
r) Viscosityno data available
s) Explosive propertiesno data available
t) Oxidizing propertiesno data available
Other safety information
no data available
Section10. STABILITY AND REACTIVITY
Reactivity
no data available
Chemical stability
no data available
Possibility of hazardous reactions
no data available
Conditions to avoid
no data available
Incompatible materials
Strong oxidizing agents
Hazardous decomposition products
Other decomposition products - no data available
Section11. TOXICOLOGICAL INFORMATION
Information on toxicological effects
Acute toxicity
no data available
Skin corrosion/irritation
no data available
Serious eye damage/eye irritation
no data available
Respiratory or skin sensitization
no data available
Germ cell mutagenicity
no data available
Carcinogenicity
IARC:No component of this product present at levels greater than or equal to 0.1% is identified as
probable, possible or confirmed human carcinogen by IARC.
Reproductive toxicity
no data available
Specific target organ toxicity - single exposure
no data available
Specific target organ toxicity - repeated exposure
no data available
Aspiration hazard
no data available
Potential health effects
InhalationMay be harmful if inhaled. Material is extremely destructive to the tissue of
the mucous membranes and upper respiratory tract.
IngestionMay be harmful if swallowed. Causes burns.
SkinMay be harmful if absorbed through skin. Causes skin burns.
EyesCauses eye burns.
Signs and Symptoms of Exposure
To the best of our knowledge, the chemical, physical, and toxicological properties have not been
thoroughly investigated.
Additional Information
RTECS: Not available
Section12. ECOLOGICAL INFORMATION
Toxicity
no data available
Persistence and degradability
no data available
Bioaccumulative potential
no data available
Mobility in soil
no data available
Results of PBT and vPvB assessment
no data available
Other adverse effects
no data available
Section13. DISPOSAL CONSIDERATIONS
Waste treatment methods
Product
Offer surplus and non-recyclable solutions to a licensed disposal company. Dissolve or mix the material
with a combustible solvent and burn in a chemical incinerator equipped with an afterburner and scrubber.
Contaminated packaging
Dispose of as unused product.
Section14. TRANSPORT INFORMATION
UN number
ADR/RID: 3261IMDG: 3261IATA: 3261
UN proper shipping name
ADR/RID: CORROSIVE SOLID, ACIDIC, ORGANIC, N.O.S. (Cyclopentadienylmolybdenum(V)
tetrachloride)
IMDG: CORROSIVE SOLID, ACIDIC, ORGANIC, N.O.S. (Cyclopentadienylmolybdenum(V)
tetrachloride)
IATA:Corrosive solid, acidic, organic, n.o.s. (Cyclopentadienylmolybdenum(V) tetrachloride)
Transport hazard class(es)
ADR/RID: 8IMDG: 8IATA: 8
Packaging group
ADR/RID: IIIMDG: IIIATA: II
Environmental hazards
ADR/RID: noIMDG Marine pollutant: noIATA: no
Special precautions for user
no data available
SECTION 15 - REGULATORY INFORMATION
N/A
SECTION 16 - ADDITIONAL INFORMATION
N/A

分子结构与计算化学数据

计算化学数据

1.疏水参数计算参考值（XlogP）:无

2.氢键供体数量:0

3.氢键受体数量:1

4.可旋转化学键数量:0

5.互变异构体数量:无

6.拓扑分子极性表面积0

7.重原子数量:10

8.表面电荷:-1

9.复杂度:129

10.同位素原子数量:0

11.确定原子立构中心数量:0

12.不确定原子立构中心数量:0

13.确定化学键立构中心数量:0

14.不确定化学键立构中心数量:0

15.共价键单元数量:2