9H-Fluoren-2-ol

物化性质

密度：

1.241g/cm3

熔点：

167-169ºC(lit.)

沸点：

372.1ºC at 760mmHg

闪点：

182ºC

折射率：

1.683

蒸汽压：

4.61E-06mmHg at 25°C

存储条件/存储方法：

密闭，避光，通风干燥处保存

稳定性相关：

1. 存在于主流烟气中。

其它信息：

1. 性状：未确定

2. 密度（g/mL 25ºC）：0.9982

3. 相对蒸汽密度（g/mL,空气=1）：未确定

4. 熔点（ºC）：167-169

5. 沸点（ºC，18mmHg）：未确定

6. 沸点（ºC,5.2kPa）：266.3

7. 折射率_(n²⁰_D) ：1.687

8. 闪点（ºC）：未确定

9. 比旋光度（º）：未确定

10. 自燃点或引燃温度（ºC）：未确定

11. 蒸气压（kPa,20ºC）：未确定

12. 饱和蒸气压（kPa,60ºC）：未确定

13. 燃烧热（KJ/mol）：未确定

14. 临界温度（ºC）：未确定

15. 临界压力（KPa）：未确定

16. 油水（辛醇/水）分配系数的对数值（25℃）：未确定

17. 爆炸上限（%,V/V）：未确定

18. 爆炸下限（%,V/V）：未确定

19. 溶解性(mg/mL, 25 ºC )：水：未确定

安全信息

密度：

1.241g/cm3

熔点：

167-169ºC(lit.)

沸点：

372.1ºC at 760mmHg

闪点：

182ºC

折射率：

1.683

蒸汽压：

4.61E-06mmHg at 25°C

存储条件/存储方法：

密闭，避光，通风干燥处保存

稳定性相关：

1. 存在于主流烟气中。

其它信息：

1. 性状：未确定

2. 密度（g/mL 25ºC）：0.9982

3. 相对蒸汽密度（g/mL,空气=1）：未确定

4. 熔点（ºC）：167-169

5. 沸点（ºC，18mmHg）：未确定

6. 沸点（ºC,5.2kPa）：266.3

7. 折射率_(n²⁰_D) ：1.687

8. 闪点（ºC）：未确定

9. 比旋光度（º）：未确定

10. 自燃点或引燃温度（ºC）：未确定

11. 蒸气压（kPa,20ºC）：未确定

12. 饱和蒸气压（kPa,60ºC）：未确定

13. 燃烧热（KJ/mol）：未确定

14. 临界温度（ºC）：未确定

15. 临界压力（KPa）：未确定

16. 油水（辛醇/水）分配系数的对数值（25℃）：未确定

17. 爆炸上限（%,V/V）：未确定

18. 爆炸下限（%,V/V）：未确定

19. 溶解性(mg/mL, 25 ºC )：水：未确定

毒理性

生态数据：

若无政府许可，勿将材料排入周围环境

MSDS

Section1. IDENTIFICATION OF THE SUBSTANCE/MIXTURE
Product identifiers
Product name: 2-Hydroxyfluorene
CAS-No.: 2443-58-5

Section2. HAZARDS IDENTIFICATION
Classification of the substance or mixture
Classification according to Regulation (EC) No 1272/2008 [EU-GHS/CLP]
Skin irritation (Category 2)
Eye irritation (Category 2)
Specific target organ toxicity - single exposure (Category 3)
Classification according to EU Directives 67/548/EEC or 1999/45/EC
Irritating to eyes, respiratory system and skin.
Label elements
Labelling according Regulation (EC) No 1272/2008 [CLP]
Pictogram
Signal wordWarning
Hazard statement(s)
Causes skin irritation.
Causes serious eye irritation.
May cause respiratory irritation.
Precautionary statement(s)
Avoid breathing dust.
P305 + P351 + P338IF IN EYES: Rinse cautiously with water for several minutes. Remove
contact lenses, if present and easy to do. Continue rinsing.
Supplemental Hazardnone
Statements
According to European Directive 67/548/EEC as amended.
Hazard symbol(s)
R-phrase(s)
R36/37/38Irritating to eyes, respiratory system and skin.
S-phrase(s)
S26In case of contact with eyes, rinse immediately with plenty of water and
seek medical advice.
S37/39Wear suitable gloves and eye/face protection.
Other hazards - none
Section3. COMPOSITION/INFORMATION ON INGREDIENTS
Substances
Synonyms: 2-Fluorenol
Formula: C13H10O
Molecular Weight: 182,22 g/mol
ComponentConcentration
9H-Fluoren-2-ol
CAS-No.2443-58-5-
EC-No.219-478-9
Section4. FIRST AID MEASURES
Description of first aid measures
General advice
Consult a physician. Show this safety data sheet to the doctor in attendance.
If inhaled
If breathed in, move person into fresh air. If not breathing, give artificial respiration. Consult a physician.
In case of skin contact
Wash off with soap and plenty of water. Consult a physician.
In case of eye contact
Rinse thoroughly with plenty of water for at least 15 minutes and consult a physician.
If swallowed
Never give anything by mouth to an unconscious person. Rinse mouth with water. Consult a physician.
Most important symptoms and effects, both acute and delayed
To the best of our knowledge, the chemical, physical, and toxicological properties have not been
thoroughly investigated.
Indication of any immediate medical attention and special treatment needed
no data available
Section5. FIREFIGHTING MEASURES
Extinguishing media
Suitable extinguishing media
Use water spray, alcohol-resistant foam, dry chemical or carbon dioxide.
Special hazards arising from the substance or mixture
Carbon oxides
Advice for firefighters
Wear self contained breathing apparatus for fire fighting if necessary.
Further information
no data available
Section6. ACCIDENTAL RELEASE MEASURES
Personal precautions, protective equipment and emergency procedures
Use personal protective equipment. Avoid dust formation. Avoid breathing vapors, mist or gas. Ensure
adequate ventilation. Evacuate personnel to safe areas. Avoid breathing dust.
Environmental precautions
Do not let product enter drains.
Methods and materials for containment and cleaning up
Pick up and arrange disposal without creating dust. Sweep up and shovel. Keep in suitable, closed
containers for disposal.
Reference to other sections
For disposal see section 13.
Section7. HANDLING AND STORAGE
Precautions for safe handling
Avoid contact with skin and eyes. Avoid formation of dust and aerosols.
Provide appropriate exhaust ventilation at places where dust is formed.
Conditions for safe storage, including any incompatibilities
Store in cool place. Keep container tightly closed in a dry and well-ventilated place.
Specific end use(s)
no data available
Section8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Control parameters
Components with workplace control parameters
Exposure controls
Appropriate engineering controls
Handle in accordance with good industrial hygiene and safety practice. Wash hands before breaks and
at the end of workday.
Personal protective equipment
Eye/face protection
Safety glasses with side-shields conforming to EN166 Use equipment for eye protection tested
and approved under appropriate government standards such as NIOSH (US) or EN 166(EU).
Skin protection
Handle with gloves. Gloves must be inspected prior to use. Use proper glove removal technique
(without touching glove's outer surface) to avoid skin contact with this product. Dispose of
contaminated gloves after use in accordance with applicable laws and good laboratory practices.
Wash and dry hands.
The selected protective gloves have to satisfy the specifications of EU Directive 89/686/EEC and
the standard EN 374 derived from it.
Body Protection
impervious clothing, The type of protective equipment must be selected according to the
concentration and amount of the dangerous substance at the specific workplace.
Respiratory protection
For nuisance exposures use type P95 (US) or type P1 (EU EN 143) particle respirator.For higher
level protection use type OV/AG/P99 (US) or type ABEK-P2 (EU EN 143) respirator cartridges.
Use respirators and components tested and approved under appropriate government standards
such as NIOSH (US) or CEN (EU).
Section9. PHYSICAL AND CHEMICAL PROPERTIES
Information on basic physical and chemical properties
a) AppearanceForm: powder
Colour: tan
b) Odourno data available
c) Odour Thresholdno data available
d) pHno data available
e) Melting point/freezingMelting point/range: 167 - 169 °C - lit.
point
f) Initial boiling point and no data available
boiling range
g) Flash pointno data available
h) Evaporation rateno data available
i) Flammability (solid, gas) no data available
j) Upper/lowerno data available
flammability or
explosive limits
k) Vapour pressureno data available
l) Vapour densityno data available
m) Relative densityno data available
n) Water solubilityno data available
o) Partition coefficient: n- no data available
octanol/water
p) Auto-ignitionno data available
temperature
q) Decompositionno data available
temperature
r) Viscosityno data available
s) Explosive propertiesno data available
t) Oxidizing propertiesno data available
Other safety information
no data available
Section10. STABILITY AND REACTIVITY
Reactivity
no data available
Chemical stability
no data available
Possibility of hazardous reactions
no data available
Conditions to avoid
no data available
Incompatible materials
Strong oxidizing agents
Hazardous decomposition products
Other decomposition products - no data available
Section11. TOXICOLOGICAL INFORMATION
Information on toxicological effects
Acute toxicity
no data available
Skin corrosion/irritation
no data available
Serious eye damage/eye irritation
no data available
Respiratory or skin sensitization
no data available
Germ cell mutagenicity
no data available
Carcinogenicity
IARC:No component of this product present at levels greater than or equal to 0.1% is identified as
probable, possible or confirmed human carcinogen by IARC.
Reproductive toxicity
no data available
Specific target organ toxicity - single exposure
Inhalation - May cause respiratory irritation.
Specific target organ toxicity - repeated exposure
no data available
Aspiration hazard
no data available
Potential health effects
InhalationMay be harmful if inhaled. Causes respiratory tract irritation.
IngestionMay be harmful if swallowed.
SkinMay be harmful if absorbed through skin. Causes skin irritation.
EyesCauses serious eye irritation.
Signs and Symptoms of Exposure
To the best of our knowledge, the chemical, physical, and toxicological properties have not been
thoroughly investigated.
Additional Information
RTECS: Not available
Section12. ECOLOGICAL INFORMATION
Toxicity
no data available
Persistence and degradability
no data available
Bioaccumulative potential
no data available
Mobility in soil
no data available
Results of PBT and vPvB assessment
no data available
Other adverse effects
no data available
Section13. DISPOSAL CONSIDERATIONS
Waste treatment methods
Product
Offer surplus and non-recyclable solutions to a licensed disposal company. Dissolve or mix the material
with a combustible solvent and burn in a chemical incinerator equipped with an afterburner and scrubber.
Contaminated packaging
Dispose of as unused product.
Section14. TRANSPORT INFORMATION
UN number
ADR/RID: -IMDG: -IATA: -
UN proper shipping name
ADR/RID: Not dangerous goods
IMDG: Not dangerous goods
IATA:Not dangerous goods
Transport hazard class(es)
ADR/RID: -IMDG: -IATA: -
Packaging group
ADR/RID: -IMDG: -IATA: -
Environmental hazards
ADR/RID: noIMDG Marine Pollutant: noIATA: no
Special precautions for user
no data available
Section15. REGULATORY INFORMATION
This safety datasheet complies with the requirements of Regulation (EC) No. 1907/2006.
Safety, health and environmental regulations/legislation specific for the substance or mixture
no data available
Chemical Safety Assessment
SECTION 16 - ADDITIONAL INFORMATION
N/A

分子结构与计算化学数据

分子结构数据

1、 摩尔折射率：55.67

2、 摩尔体积（cm³/mol）：146.7

3、 等张比容（90.2K）：401.7

4、 表面张力（dyne/cm）：56.1

5、 介电常数（F/m）：无可用

6、 偶极距（D）：无可用

7、 极化率（10-24cm³）：22.07

计算化学数据

1.疏水参数计算参考值（XlogP）:无

2.氢键供体数量:1

3.氢键受体数量:1

4.可旋转化学键数量:0

5.互变异构体数量:9

6.拓扑分子极性表面积20.2

7.重原子数量:14

8.表面电荷:0

9.复杂度:213

10.同位素原子数量:0

11.确定原子立构中心数量:0

12.不确定原子立构中心数量:0

13.确定化学键立构中心数量:0

14.不确定化学键立构中心数量:0

15.共价键单元数量:1