9,12,15-Octadecatrienoylchloride, (9Z,12Z,15Z)-

物化性质

密度：

0.942g/cm3

沸点：

382.9ºC at 760 mmHg

闪点：

184.8ºC

折射率：

1.478-1.48

存储条件/存储方法：

密闭于阴凉干燥环境中

稳定性相关：

遵照规定使用和储存则不会分解。

其它信息：

1.性状：无可用

2.密度（g/mL,25/4℃）：无可用

3.相对蒸汽密度（g/mL,空气=1）：无可用

4.熔点（ºC）：无可用

5.沸点（ºC,常压）：无可用

6.沸点（ºC,5.2kPa）：无可用

7.折射率：1.478-1.48

8.闪点（ºC）：无可用

9.比旋光度（º）：无可用

10.自燃点或引燃温度（ºC）：无可用

11.蒸气压（kPa,25ºC）：无可用

12.饱和蒸气压（kPa,60ºC）：无可用

13.燃烧热（KJ/mol）：无可用

14.临界温度（ºC）：无可用

15.临界压力（KPa）：无可用

16.油水（辛醇/水）分配系数的对数值：无可用

17.爆炸上限（%,V/V）：无可用

18.爆炸下限（%,V/V）：无可用

19.溶解性：无可用

安全信息

密度：

0.942g/cm3

沸点：

382.9ºC at 760 mmHg

闪点：

184.8ºC

折射率：

1.478-1.48

存储条件/存储方法：

密闭于阴凉干燥环境中

稳定性相关：

遵照规定使用和储存则不会分解。

其它信息：

1.性状：无可用

2.密度（g/mL,25/4℃）：无可用

3.相对蒸汽密度（g/mL,空气=1）：无可用

4.熔点（ºC）：无可用

5.沸点（ºC,常压）：无可用

6.沸点（ºC,5.2kPa）：无可用

7.折射率：1.478-1.48

8.闪点（ºC）：无可用

9.比旋光度（º）：无可用

10.自燃点或引燃温度（ºC）：无可用

11.蒸气压（kPa,25ºC）：无可用

12.饱和蒸气压（kPa,60ºC）：无可用

13.燃烧热（KJ/mol）：无可用

14.临界温度（ºC）：无可用

15.临界压力（KPa）：无可用

16.油水（辛醇/水）分配系数的对数值：无可用

17.爆炸上限（%,V/V）：无可用

18.爆炸下限（%,V/V）：无可用

19.溶解性：无可用

毒理性

生态数据：

该物质对环境可能有危害，对水体应给予特别注意。

MSDS

Name:	Linolenoyl Chloride (Pract) Material Safety Data Sheet
Synonym:	None known
CAS:	59044-29-0

Section 1 - Chemical Product   MSDS Name:Linolenoyl Chloride (Pract) Material Safety Data Sheet
Synonym:None known
Section 2 - COMPOSITION, INFORMATION ON INGREDIENTS

CAS#	Chemical Name	content	EINECS#
59044-29-0	9,12,15-Octadecatrienoyl Chloride, (Z,	ca 100	261-572-7

Hazard Symbols: C
Risk Phrases: 34
Section 3 - HAZARDS IDENTIFICATION
  EMERGENCY OVERVIEW
Causes burns.Corrosive.
Potential Health Effects
Eye:
Causes eye burns. May cause chemical conjunctivitis and corneal damage.
Skin:
Causes skin burns. May cause skin rash (in milder cases), and cold and clammy skin with cyanosis or pale color.
Ingestion:
May cause severe and permanent damage to the digestive tract. Causes gastrointestinal tract burns. May cause perforation of the digestive tract. The toxicological properties of this substance have not been fully investigated. May cause systemic effects.
Inhalation:
Causes chemical burns to the respiratory tract. The toxicological properties of this substance have not been fully investigated.
Aspiration may lead to pulmonary edema. May cause systemic effects.
Chronic:
Effects may be delayed.
Section 4 - FIRST AID MEASURES
  Eyes: Get medical aid. Do NOT allow victim to rub eyes or keep eyes closed. Extensive irrigation with water is required (at least 30 minutes).
Skin:
Get medical aid immediately. Immediately flush skin with plenty of water for at least 15 minutes while removing contaminated clothing and shoes. Wash clothing before reuse. Destroy contaminated shoes.
Ingestion:
Get medical aid. Do NOT induce vomiting. If conscious and alert, rinse mouth and drink 2-4 cupfuls of milk or water.
Inhalation:
Get medical aid immediately. Remove from exposure and move to fresh air immediately. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Do NOT use mouth-to-mouth resuscitation. If breathing has ceased apply artificial respiration using oxygen and a suitable mechanical device such as a bag and a mask.
Notes to Physician:
Section 5 - FIRE FIGHTING MEASURES
  General Information:
As in any fire, wear a self-contained breathing apparatus in pressure-demand, MSHA/NIOSH (approved or equivalent), and full protective gear. During a fire, irritating and highly toxic gases may be generated by thermal decomposition or combustion. Use water spray to keep fire-exposed containers cool. Vapors may be heavier than air. They can spread along the ground and collect in low or confined areas. Containers may explode when heated.
Extinguishing Media:
Use agent most appropriate to extinguish fire. Cool containers with flooding quantities of water until well after fire is out. Use water spray, dry chemical, carbon dioxide, or appropriate foam.
Section 6 - ACCIDENTAL RELEASE MEASURES
  General Information: Use proper personal protective equipment as indicated in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth), then place in suitable container. Avoid runoff into storm sewers and ditches which lead to waterways. Clean up spills immediately, observing precautions in the Protective Equipment section. Remove all sources of ignition. Provide ventilation.
Section 7 - HANDLING and STORAGE
  Handling:
Wash thoroughly after handling. Remove contaminated clothing and wash before reuse. Use with adequate ventilation. Avoid contact with eyes, skin, and clothing. Keep container tightly closed. Avoid ingestion and inhalation. Discard contaminated shoes.
Storage:
Store in a tightly closed container. Store in a cool, dry, well-ventilated area away from incompatible substances. Corrosives area.
Section 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION
  Engineering Controls:
Facilities storing or utilizing this material should be equipped with an eyewash facility and a safety shower. Use adequate ventilation to keep airborne concentrations low.
Exposure Limits CAS# 59044-29-0: Personal Protective Equipment Eyes: Wear appropriate protective eyeglasses or chemical safety goggles as described by OSHA's eye and face protection regulations in 29 CFR 1910.133 or European Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin exposure.
Clothing:
Wear appropriate protective clothing to prevent skin exposure.
Respirators:
A respiratory protection program that meets OSHA's 29 CFR 1910.134 and ANSI Z88.2 requirements or European Standard EN 149 must be followed whenever workplace conditions warrant respirator use.
Section 9 - PHYSICAL AND CHEMICAL PROPERTIES
 
Physical State: Liquid
Color: colorless
Odor: chlorine-like
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: Not available.
Freezing/Melting Point: Not available.
Autoignition Temperature: Not available.
Flash Point: > 110 deg C (> 230.00 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water:
Specific Gravity/Density:
Molecular Formula: C18H29ClO
Molecular Weight: 296.88
Section 10 - STABILITY AND REACTIVITY
  Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, ignition sources, excess heat, strong oxidants.
Incompatibilities with Other Materials:
Strong oxidizing agents, strong acids.
Hazardous Decomposition Products:
Carbon monoxide, irritating and toxic fumes and gases, carbon dioxide, chlorine, oxides of chlorine.
Hazardous Polymerization: Has not been reported
Section 11 - TOXICOLOGICAL INFORMATION
  RTECS#:
CAS# 59044-29-0 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
9,12,15-Octadecatrienoyl Chloride, (Z,Z,Z)- - Not listed by ACGIH, IARC, or NTP.
Section 12 - ECOLOGICAL INFORMATION
 
Section 13 - DISPOSAL CONSIDERATIONS
  Dispose of in a manner consistent with federal, state, and local regulations.
Section 14 - TRANSPORT INFORMATION
 
IATA
Shipping Name: CORROSIVE LIQUID, ACIDIC, ORGANIC, N.O.S.*
Hazard Class: 8
UN Number: 3265
Packing Group: III
IMO
Shipping Name: CORROSIVE LIQUID, ACIDIC, ORGANIC, N.O.S.
Hazard Class: 8
UN Number: 3265
Packing Group: III
RID/ADR
Shipping Name: CORROSIVE LIQUID, ACIDIC, ORGANIC, N.O.S.
Hazard Class: 8
UN Number: 3265
Packing group: III
Section 15 - REGULATORY INFORMATION
 
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: C
Risk Phrases:
R 34 Causes burns.
Safety Phrases:
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
S 28A After contact with skin, wash immediately with
plenty of water.
S 37 Wear suitable gloves.
S 45 In case of accident or if you feel unwell, seek
medical advice immediately (show the label where
possible).
WGK (Water Danger/Protection)
CAS# 59044-29-0: No information available.
Canada
CAS# 59044-29-0 is listed on Canada's DSL List.
CAS# 59044-29-0 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 59044-29-0 is listed on the TSCA inventory.

SECTION 16 - ADDITIONAL INFORMATION
N/A

分子结构与计算化学数据

分子结构数据

1、摩尔折射率：90.49

2、摩尔体积（m³/mol）：315.0

3、等张比容（90.2K）：753.4

4、表面张力（dyne/cm）：32.7

5、极化率（10^-24cm³）：35.87

计算化学数据

1、疏水参数计算参考值（XlogP）：6.9

2、氢键供体数量：0

3、氢键受体数量：1

4、可旋转化学键数量：13

5、拓扑分子极性表面积（TPSA）：17.1

6、重原子数量：20

7、表面电荷：0

8、复杂度：303

9、同位素原子数量：0

10、确定原子立构中心数量：0

11、不确定原子立构中心数量：0

12、确定化学键立构中心数量：3

13、不确定化学键立构中心数量：0

14、共价键单元数量：1