9,10-Bis(diethylphosphonomethyl)anthracene

物化性质

密度：

1.207g/cm3

沸点：

634.9ºC at 760 mmHg

闪点：

350.4ºC

折射率：

1.567

存储条件/存储方法：

在密封的贮藏器内，并放置阴凉，干燥的地方保存

稳定性相关：

避免接触氧化物

其它信息：

1. 性状：未确定

2. 密度（g/cm³ 20 ºC ）：未确定

3. 相对蒸汽密度（g/mL,空气=1）：未确定

4. 熔点（ºC）：未确定

5. 沸点（ºC，12mmHg）：未确定

6. 沸点（ºC,5.2kPa）：未确定

7. 折射率（°）：未确定

8. 闪点（ºC，3mmHg）：未确定

9. 比旋光度（º）：未确定

10. 自燃点或引燃温度（ºC）：未确定

11. 蒸气压（kPa,25ºC）：未确定

12. 饱和蒸气压（kPa,60ºC）：未确定

13. 燃烧热（KJ/mol）：未确定

14. 临界温度（ºC）：未确定

15. 临界压力（KPa）：未确定

16. 油水（辛醇/水）分配系数的对数值（25℃）：未确定

17. 爆炸上限（%,V/V）：未确定

18. 爆炸下限（%,V/V）：未确定

19. 溶解性(mg/mL)：水：未确定

安全信息

密度：

1.207g/cm3

沸点：

634.9ºC at 760 mmHg

闪点：

350.4ºC

折射率：

1.567

存储条件/存储方法：

在密封的贮藏器内，并放置阴凉，干燥的地方保存

稳定性相关：

避免接触氧化物

其它信息：

1. 性状：未确定

2. 密度（g/cm³ 20 ºC ）：未确定

3. 相对蒸汽密度（g/mL,空气=1）：未确定

4. 熔点（ºC）：未确定

5. 沸点（ºC，12mmHg）：未确定

6. 沸点（ºC,5.2kPa）：未确定

7. 折射率（°）：未确定

8. 闪点（ºC，3mmHg）：未确定

9. 比旋光度（º）：未确定

10. 自燃点或引燃温度（ºC）：未确定

11. 蒸气压（kPa,25ºC）：未确定

12. 饱和蒸气压（kPa,60ºC）：未确定

13. 燃烧热（KJ/mol）：未确定

14. 临界温度（ºC）：未确定

15. 临界压力（KPa）：未确定

16. 油水（辛醇/水）分配系数的对数值（25℃）：未确定

17. 爆炸上限（%,V/V）：未确定

18. 爆炸下限（%,V/V）：未确定

19. 溶解性(mg/mL)：水：未确定

毒理性

生态数据：

若无政府许可，勿将材料排入周围环境

MSDS

Section I.Chemical Product and Company Identification
Chemical Name 9,10-Bis(diethylphosphonomethyl)anthracene
Portland OR
SynonymPhosphonic acid, P,P'-[9,10-anthracenediylbis
(methylene)]bis-, P,P,P',P'-tetraethyl ester (CA INDEX
NAME);
Tetraethyl [Anthracene-9,10-diylbis(methylene)]bisphos
phonate; [Anthracene-9,10-diylbis(methylene)]bisphos
phonic Acid Tetraethyl Ester
Chemical FormulaC24H32O6P2
In case ofChemtrec®
CAS Number60974-92-7
Section II.Composition and Information on Ingredients
Toxicology Data
Chemical NameCAS Number Percent (%)TLV/PEL
60974-92-7 Min. 98.0 (GC) Not available.Not available.
9,10-Bis(diethylphosphonomethyl)anthracene
Section III. Hazards Identification
Acute Health EffectsNo specific information is available in our data base regarding the toxic effects of this material for humans. However,
exposure to any chemical should be kept to a minimum. Skin and eye contact may result in irritation. May be harmful if
inhaled or ingested. Always follow safe industrial hygiene practices and wear proper protective equipment when handling
this compound.
Follow safe industrial hygiene practices and always wear proper protective equipment when handling this compound.
Chronic Health EffectsCARCINOGENIC EFFECTS : Not available.
MUTAGENIC EFFECTS : Not available.
TERATOGENIC EFFECTS : Not available.
DEVELOPMENTAL TOXICITY: Not available.
Repeated or prolonged exposure to this compound is not known to aggravate existing medical conditions.
Section IV.First Aid Measures
Check for and remove any contact lenses. In case of contact, immediately flush eyes with plenty of water for at least 15
Eye Contact
minutes. Get medical attention.
Skin ContactIn case of contact, immediately flush skin with plenty of water. Remove contaminated clothing and shoes. Wash clothing
before reuse. Thoroughly clean shoes before reuse. Get medical attention.
If the victim is not breathing, perform mouth-to-mouth resuscitation. Loosen tight clothing such as a collar, tie, belt or
Inhalation
waistband. If breathing is difficult, oxygen can be administered. Seek medical attention if respiration problems do not
improve.
IngestionINDUCE VOMITING by sticking finger in throat. Lower the head so that the vomit will not reenter the mouth and throat.
Loosen tight clothing such as a collar, tie, belt or waistband. If the victim is not breathing, perform mouth-to-mouth
resuscitation. Examine the lips and mouth to ascertain whether the tissues are damaged, a possible indication that the toxic
material was ingested; the absence of such signs, however, is not conclusive.
Section V.Fire and Explosion Data
Not available.
May be combustible at high temperature.Auto-Ignition
Flammability
Flash PointsFlammable LimitsNot available.
Not available.
These products are toxic carbon oxides (CO, CO2), phosphates.
Combustion Products
Fire Hazards
Not available.
Risks of explosion of the product in presence of mechanical impact: Not available.
Explosion Hazards
Risks of explosion of the product in presence of static discharge: Not available.
Fire Fighting Media
SMALL FIRE: Use DRY chemical powder.
LARGE FIRE: Use water spray, fog or foam. DO NOT use water jet.
and Instructions
Consult with local fire authorities before attempting large scale fire-fighting operations.
Continued on Next Page
9,10-Bis(diethylphosphonomethyl)anthracene
Section VI.Accidental Release Measures
Spill CleanupUse a shovel to put the material into a convenient waste disposal container. Finish cleaning the spill by rinsing any
contaminated surfaces with copious amounts of water. Consult federal, state, and/or local authorities for assistance on
Instructions
disposal.
Section VII. Handling and Storage
Handling and StorageKeep away from heat. Mechanical exhaust required. When not in use, tightly seal the container and store in a dry, cool
place. Avoid excessive heat and light. Do not breathe dust.
Information
Always store away from incompatible compounds such as oxidizing agents.
Section VIII. Exposure Controls/Personal Protection
Use process enclosures, local exhaust ventilation, or other engineering controls to keep airborne levels below recommended
Engineering Controls
exposure limits. If user operations generate dust, fume or mist, use ventilation to keep exposure to airborne contaminants
below the exposure limit.
Splash goggles. Lab coat. Dust respirator. Boots. Gloves. Suggested protective clothing might not be sufficient; consult a
Personal Protection
specialist BEFORE handling this product. Be sure to use a MSHA/NIOSH approved respirator or equivalent.
Exposure LimitsNot available.
Section IX. Physical and Chemical Properties
Solid. (yellow powder)Solubility
Physical state @ 20°CSoluble in toluene.
Not available.
Specific Gravity
478.45
Molecular WeightPartition CoefficientNot available.
Boiling PointNot available.Vapor PressureNot applicable.
Not available.Not available.
Melting PointVapor Density
Not available.VolatilityNot available.
Refractive Index
Not available.
Critical TemperatureNot available.Odor
ViscosityNot available.TasteNot available.
Section X.Stability and Reactivity Data
StabilityThis material is stable if stored under proper conditions. (See Section VII for instructions)
Conditions of InstabilityAvoid excessive heat and light.
Incompatibilities
Reactive with oxidizing agents.
Section XI. Toxicological Information
Not available.
RTECS Number
Routes of ExposureEye Contact. Ingestion. Inhalation.
Not available.
Toxicity Data
Chronic Toxic EffectsCARCINOGENIC EFFECTS : Not available.
MUTAGENIC EFFECTS : Not available.
TERATOGENIC EFFECTS : Not available.
DEVELOPMENTAL TOXICITY: Not available.
Repeated or prolonged exposure to this compound is not known to aggravate existing medical conditions.
Acute Toxic EffectsNo specific information is available in our data base regarding the toxic effects of this material for humans. However,
exposure to any chemical should be kept to a minimum. Skin and eye contact may result in irritation. May be harmful if
inhaled or ingested. Always follow safe industrial hygiene practices and wear proper protective equipment when handling this
compound.
Follow safe industrial hygiene practices and always wear proper protective equipment when handling this compound.
Section XII.Ecological Information
Not available.
Ecotoxicity
Not available.
Environmental Fate
Continued on Next Page
9,10-Bis(diethylphosphonomethyl)anthracene
Section XIII. Disposal Considerations
Waste DisposalRecycle to process, if possible. Consult your local regional authorities. You may be able to dissolve or mix material with a
combustible solvent and burn in a chemical incinerator equipped with an afterburner and scrubber system. Observe all
federal, state and local regulations when disposing of the substance.
Section XIV. Transport Information
Not a DOT controlled material (United States).
DOT Classification
PIN NumberNot applicable.
Proper Shipping NameNot applicable.
Packing Group (PG)Not applicable.
DOT Pictograms
Section XV. Other Regulatory Information and Pictograms
TSCA Chemical InventoryThis product is NOT on the EPA Toxic Substances Control Act (TSCA) inventory. The following notices are required by 40
CFR 720.36 (C) for those products not on the inventory list:
(EPA)
(i) These products are supplied solely for use in research and development by or under the supervision of a technically
qualified inpidual as defined in 40 CFR 720.0 et sec.
(ii) The health risks of these products have not been fully determined. Any information that is or becomes available will be
supplied on an MSDS sheet.
WHMIS ClassificationNot controlled under WHMIS (Canada).
(Canada)
EINECS Number (EEC)Not available.
EEC Risk StatementsNot available.
SECTION 16 - ADDITIONAL INFORMATION
N/A

海关数据

中国海关编码：2916190090

概述：

2916190090 其他不饱和无环一元羧酸（包括其酸酐、酰卤化物，过氧化物和过氧酸以及它们的衍生物）。监管条件:AB(入境货物通关单,出境货物通关单)。增值税率:17.0%。退税率:9.0%。最惠国关税:6.5%。普通关税:30.0%

申报要素：

品名, 成分含量, 用途, 丙烯酸、丙烯酸盐或酯应报明包装

监管条件：

A.入境货物通关单B.出境货物通关单

检验检疫：

R.进口食品卫生监督检验S.出口食品卫生监督检验M.进口商品检验N.出口商品检验

摘要/Summary：

2916190090 unsaturated acyclic monocarboxylic acids, their anhydrides, halides, peroxides, peroxyacids and their derivatives。supervision conditions:AB(certificate of inspection for goods inward,certificate of inspection for goods outward)。VAT:17.0%。tax rebate rate:9.0%。MFN tariff:6.5%。general tariff:30.0%

分子结构与计算化学数据

计算化学数据

1.疏水参数计算参考值（XlogP）:4

2.氢键供体数量:0

3.氢键受体数量:6

4.可旋转化学键数量:12

5.互变异构体数量:无

6.拓扑分子极性表面积71.1

7.重原子数量:32

8.表面电荷:0

9.复杂度:571

10.同位素原子数量:0

11.确定原子立构中心数量:0

12.不确定原子立构中心数量:0

13.确定化学键立构中心数量:0

14.不确定化学键立构中心数量:0

15.共价键单元数量:1