1H-Pyrrole-2,5-dione,1-(phenylmethyl)-

物化性质

外观与性状：

片状

密度：

1 g/cm3

熔点：

70 °C(lit.)

沸点：

177 °C / 20mmHg

闪点：

157.9ºC

水溶解性：

Insoluble

折射率：

1.625

蒸汽压：

9.61E-05mmHg at 25°C

存储条件/存储方法：

保持容器密封，储存在阴凉，干燥的地方

稳定性相关：

常温常压下稳定，避免氧化物 酸 碱接触

其它信息：

1. 性状：固体。

2. 密度（g/mL,25/4℃）： 1

3. 相对蒸汽密度（g/mL,空气=1）：未确定

4. 熔点（ºC）：70-72

5. 沸点（ºC,常压）：177

6. 沸点（ºC,5.2kPa）： 未确定

7. 折射率： 未确定

8. 闪点（ºC）： 157

9. 比旋光度（º）： 未确定

10. 自燃点或引燃温度（ºC）： 未确定

11. 蒸气压（kPa,25ºC）： 未确定

12. 饱和蒸气压（kPa,60ºC）： 未确定

13. 燃烧热（KJ/mol）：未确定

14. 临界温度（ºC）： 未确定

15. 临界压力（KPa）： 未确定

16. 油水（辛醇/水）分配系数的对数值： 1.78

17. 爆炸上限（%,V/V）：未确定

18. 爆炸下限（%,V/V）： 未确定

19. 溶解性：能溶于水。

安全信息

外观与性状：

片状

密度：

1 g/cm3

熔点：

70 °C(lit.)

沸点：

177 °C / 20mmHg

闪点：

157.9ºC

水溶解性：

Insoluble

折射率：

1.625

蒸汽压：

9.61E-05mmHg at 25°C

存储条件/存储方法：

保持容器密封，储存在阴凉，干燥的地方

稳定性相关：

常温常压下稳定，避免氧化物 酸 碱接触

其它信息：

1. 性状：固体。

2. 密度（g/mL,25/4℃）： 1

3. 相对蒸汽密度（g/mL,空气=1）：未确定

4. 熔点（ºC）：70-72

5. 沸点（ºC,常压）：177

6. 沸点（ºC,5.2kPa）： 未确定

7. 折射率： 未确定

8. 闪点（ºC）： 157

9. 比旋光度（º）： 未确定

10. 自燃点或引燃温度（ºC）： 未确定

11. 蒸气压（kPa,25ºC）： 未确定

12. 饱和蒸气压（kPa,60ºC）： 未确定

13. 燃烧热（KJ/mol）：未确定

14. 临界温度（ºC）： 未确定

15. 临界压力（KPa）： 未确定

16. 油水（辛醇/水）分配系数的对数值： 1.78

17. 爆炸上限（%,V/V）：未确定

18. 爆炸下限（%,V/V）： 未确定

19. 溶解性：能溶于水。

毒理性

毒理学数据：

对眼睛、皮肤、粘膜有刺激作用。

生态数据：

对水是稍微有害的，不要让未稀释或大量的产品接触地下水，水道或者污水系统，若无政府许可，勿将材料排入周围环境

MSDS

Name:	N-Benzylmaleimide Material Safety Data Sheet
Synonym:	None Known
CAS:	1631-26-1

Section 1 - Chemical Product   MSDS Name:N-Benzylmaleimide Material Safety Data Sheet
Synonym:None Known
Section 2 - COMPOSITION, INFORMATION ON INGREDIENTS

CAS#	Chemical Name	content	EINECS#
1631-26-1	N-Benzylmaleimide	ca. 100	216-631-1

Hazard Symbols: C
Risk Phrases: 34
Section 3 - HAZARDS IDENTIFICATION
  EMERGENCY OVERVIEW
Causes burns.Corrosive.
Potential Health Effects
Eye:
Causes eye burns. May cause chemical conjunctivitis and corneal damage.
Skin:
Causes skin burns. May cause skin rash (in milder cases), and cold and clammy skin with cyanosis or pale color.
Ingestion:
May cause severe and permanent damage to the digestive tract. Causes gastrointestinal tract burns. May cause perforation of the digestive tract. The toxicological properties of this substance have not been fully investigated. May cause systemic effects.
Inhalation:
Causes chemical burns to the respiratory tract. The toxicological properties of this substance have not been fully investigated.
Aspiration may lead to pulmonary edema. May cause systemic effects.
Chronic:
Effects may be delayed.
Section 4 - FIRST AID MEASURES
  Eyes: Get medical aid immediately. Do NOT allow victim to rub eyes or keep eyes closed. Extensive irrigation with water is required (at least 30 minutes).
Skin:
Get medical aid immediately. Immediately flush skin with plenty of water for at least 15 minutes while removing contaminated clothing and shoes. Wash clothing before reuse. Destroy contaminated shoes.
Ingestion:
Do not induce vomiting. If victim is conscious and alert, give 2-4 cupfuls of milk or water. Never give anything by mouth to an unconscious person. Get medical aid immediately.
Inhalation:
Get medical aid immediately. Remove from exposure and move to fresh air immediately. If breathing is difficult, give oxygen. Do NOT use mouth-to-mouth resuscitation. If breathing has ceased apply artificial respiration using oxygen and a suitable mechanical device such as a bag and a mask.
Notes to Physician:
Section 5 - FIRE FIGHTING MEASURES
  General Information:
As in any fire, wear a self-contained breathing apparatus in pressure-demand, MSHA/NIOSH (approved or equivalent), and full protective gear. During a fire, irritating and highly toxic gases may be generated by thermal decomposition or combustion.
Extinguishing Media:
Use water spray, dry chemical, carbon dioxide, or chemical foam.
Section 6 - ACCIDENTAL RELEASE MEASURES
  General Information: Use proper personal protective equipment as indicated in Section 8.
Spills/Leaks:
Vacuum or sweep up material and place into a suitable disposal container. Clean up spills immediately, observing precautions in the Protective Equipment section. Avoid generating dusty conditions.
Provide ventilation.
Section 7 - HANDLING and STORAGE
  Handling:
Minimize dust generation and accumulation. Do not breathe dust, vapor, mist, or gas. Do not get in eyes, on skin, or on clothing.
Keep container tightly closed. Do not ingest or inhale. Use only in a chemical fume hood. Discard contaminated shoes.
Storage:
Store in a cool, dry place. Store in a tightly closed container.
Corrosives area.
Section 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION
  Engineering Controls:
Facilities storing or utilizing this material should be equipped with an eyewash facility and a safety shower. Use adequate ventilation to keep airborne concentrations low.
Exposure Limits CAS# 1631-26-1: Personal Protective Equipment Eyes: Wear appropriate protective eyeglasses or chemical safety goggles as described by OSHA's eye and face protection regulations in 29 CFR 1910.133 or European Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin exposure.
Clothing:
Wear appropriate protective clothing to prevent skin exposure.
Respirators:
Follow the OSHA respirator regulations found in 29 CFR 1910.134 or European Standard EN 149. Use a NIOSH/MSHA or European Standard EN 149 approved respirator if exposure limits are exceeded or if irritation or other symptoms are experienced.
Section 9 - PHYSICAL AND CHEMICAL PROPERTIES
 
Physical State: Solid
Color: Not available.
Odor: Not available.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: Not available.
Freezing/Melting Point: 70 deg C
Autoignition Temperature: Not available.
Flash Point: Not available.
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water:
Specific Gravity/Density:
Molecular Formula: C11H9NO2
Molecular Weight: 187.20
Section 10 - STABILITY AND REACTIVITY
  Chemical Stability:
Stable at room temperature in closed containers under normal storage and handling conditions.
Conditions to Avoid:
Incompatible materials, dust generation.
Incompatibilities with Other Materials:
Oxidizing agents.
Hazardous Decomposition Products:
Nitrogen oxides, carbon monoxide, carbon dioxide.
Hazardous Polymerization: Has not been reported
Section 11 - TOXICOLOGICAL INFORMATION
  RTECS#:
CAS# 1631-26-1 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
N-Benzylmaleimide - Not listed by ACGIH, IARC, or NTP.
Section 12 - ECOLOGICAL INFORMATION
  Ecotoxicity:
Fish: Pseudomonas putida:
Section 13 - DISPOSAL CONSIDERATIONS
  Dispose of in a manner consistent with federal, state, and local regulations.
Section 14 - TRANSPORT INFORMATION
 
IATA
Shipping Name: NOT REVIEWED.
Hazard Class:
UN Number:
Packing Group:
IMO
Shipping Name: NOT REVIEWED.
Hazard Class:
UN Number:
Packing Group:
RID/ADR
Shipping Name: NOT REVIEWED.
Hazard Class:
UN Number:
Packing group:
Section 15 - REGULATORY INFORMATION
 
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: C
Risk Phrases:
R 34 Causes burns.
Safety Phrases:
S 25 Avoid contact with eyes.
S 36/37/39 Wear suitable protective clothing, gloves
and eye/face protection.
S 45 In case of accident or if you feel unwell, seek
medical advice immediately (show the label where
possible).
WGK (Water Danger/Protection)
CAS# 1631-26-1: No information available.
Canada
None of the chemicals in this product are listed on the DSL/NDSL list.
CAS# 1631-26-1 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 1631-26-1 is not listed on the TSCA inventory.
It is for research and development use only.

SECTION 16 - ADDITIONAL INFORMATION
N/A

海关数据

中国海关编码：2925190090

概述：

2925190090 其他酰亚胺及其衍生物盐. 增值税率:17.0% 退税率:9.0% 监管条件:无 最惠国关税:6.5% 普通关税:30.0%

申报要素：

品名, 成分含量, 用途

摘要/Summary：

2925190090 other imides and their derivatives; salts thereof VAT:17.0% Tax rebate rate:9.0% Supervision conditions:none MFN tariff:6.5% General tariff:30.0%

分子结构与计算化学数据

分子结构数据

1、 摩尔折射率：51.04

2、 摩尔体积（m³/mol）：144.3

3、 等张比容（90.2K）：398.7

4、 表面张力（dyne/cm）：58.1

5、 介电常数（F/m）：不可用

6、 极化率（10^-24cm³）：20.23

计算化学数据

1.疏水参数计算参考值（XlogP）:1

2.氢键供体数量:0

3.氢键受体数量:2

4.可旋转化学键数量:2

5.互变异构体数量:无

6.拓扑分子极性表面积37.4

7.重原子数量:14

8.表面电荷:0

9.复杂度:259

10.同位素原子数量:0

11.确定原子立构中心数量:0

12.不确定原子立构中心数量:0

13.确定化学键立构中心数量:0

14.不确定化学键立构中心数量:0

15.共价键单元数量:1